Lamp information, Getting to know the lamp hour

Lamp information

Getting to know the lamp hour

When the projector is in operation, the duration (in hours) of lamp usage is automatically calculated by the built-in timer. The method of calculating the equivalent lamp hour is as follows:

Total (equivalent) lamp hour

= 1 (hours used in Economic mode) + 4/3 (hours used in normal mode)

See "Setting Lamp mode eco function as Economic or Smart Eco mode" below for more information on Economic mode.

The lamp hour in Economic mode is calculated as 3/4 of that in Normal mode. That is, using the projector in Economic mode helps to extend the lamp hour by 1/3.

To obtain the lamp hour information:

1.Press Menu/Exit and then press / until the SYSTEM SETUP: Advanced menu is highlighted.

2.Press to highlight Lamp Settings and press Mode/Enter. The Lamp Settings page displays.

3.You will see the Equivalent lamp hour information displaying on the menu.

4.To leave the menu, press Menu/Exit.

You can also get the lamp hour information on the INFORMATION menu.

Extending lamp life

The projection lamp is a consumable item. To keep the lamp life as long as possible, you can do the following settings via the OSD menu or remote control.

Setting Lamp mode eco function as Economic or Smart Eco mode

Using Economic /Smart Eco mode will reduces system noise and power consumption. If the Economic/Smart Eco mode is selected, the light output will be reduced and result in darker projected pictures, the projector protected for longer working life.

Setting the projector in Economic/Smart Eco mode also extends the lamp operation life. To set Economic/Smart Eco mode, go into the SYSTEM SETUP: Advanced > Lamp Settings > Lamp mode menu and press / . .

The lamp modes are defined as the chart below.

	Lamp mode	Description
	Normal	100% lamp brightness.
	Economic	80% lamp power consumption.
	Smart Eco	This is default setting. Lamp power consumption will save from 30% to
	Smart Eco	100% dynamically by detecting the content brightness level.
		100% dynamically by detecting the content brightness level.

Setting Auto Power Off

This function allows the projector to turn off automatically if no input source is detected after a set period of time to prevent unnecessary waste of lamp life.

To set Auto Power Off, go into the SYSTEM SETUP: Basic > Auto Power Off

menu and press / . The time period can be set from 5 to 30 minutes in 5-minute increments. If the preset time lengths are not suitable for your presentation, select Disable. The projector will not automatically shut down in a certain time period.

60 Maintenance