Safety instructions (continued)
5. Do not block the ventilation holes whilst the 9. | Do not look straight into the projector lens |
projector is on (even in standby mode): | during operation. It may harm your sight. |
- Do not cover the projector with any item; |
|
- Do not place the projector on a blanket, bedding or any other soft surface.
English
6. In areas where the mains power supply | 10. Do not operate the projector lamp beyond the |
rated lamp life. Excessive operation of lamps | |
voltage may fluctuate by ±10 volts, it is | beyond the rated life could cause a lamp to |
recommended that you connect your | break on rare occasions. |
projector through a power stabilizer, surge |
|
protector or uninterruptible power supply |
|
(UPS) as appropriate to your situation. |
|
7. Do not step on the projector or place any | 11. The lamp becomes extremely hot during |
operation. Allow the projector to cool for | |
objects upon it. | approximately 45 minutes prior to removing |
| the lamp assembly for replacement. |
8. Do not place liquids near or on the projector. Liquids spilled into the projector will void your warranty. If the projector does become wet, disconnect it from the power point and call BenQ to have the projector repaired.
Safety, regulatory and legal information | 7 |