ATM/POS Bridge | Configuration en 15 |
|
|
5Configuration
You must configure the ATM/POS Bridge network settings to ensure proper communication on an existing TCP/IP network. This section provides configuration details using the
To configure the bridge using a HyperTerminal session, refer to Section 6 Configuration Using HyperTerminal, page 24.
For instructions to update the ATM/POS Bridge firmware, refer to Section A Updating Bridge Firmware, page 36.
5.1Configuring the Bridge for a Network Connection
The ATM/POS Bridge allows two methods to configure network settings:
–Use the Bridge Detector utility (supplied on the
Section 5.2.2 Network Setup, page 19). or
–Use a
5.1.1Using the Bridge Detector Utility
NOTICE!
Contact your local network administrator for a valid IP Address, Subnet Mask, and a Gateway IP Address.
1.Connect the supplied DC power adapter unit to the DC power input connector of the bridge.
2.Connect the RJ45 connector of the bridge via a straight Ethernet CAT5 network cable to a network switch or hub that supports 10BaseT.
Bosch Security Systems, Inc. | Installation Manual | F.01U.171.816 1.0 2010.09 |