Bosch Appliances DVRXEAP01 installation manual Service Menu

Page 32

32 en Configuration Using HyperTerminal	ATM/POS Bridge

6.3.6Service Menu

The System Menu contains settings for bridge operation.

–Restore Defaults: Resets all COM and Terminal settings to factory defaults. This button does not reset the Network settings.

–Reset Bridge: Reboots the bridge by cycling the power.

–Diagnostics: Select this option to perform the EEPROM diagnostic test.

–Version Info: Displays the firmware release level for the bridge.

F.01U.171.816 1.0 2010.09

Installation Manual

Bosch Security Systems, Inc.

Image 32

Contents ATM/POS Bridge Page Table of Contents Configuration Using HyperTerminal Troubleshooting Technical Data Updating Bridge FirmwareSafety Type numbersEn Safety ATM/POS Bridge FCC & Ices compliance FCC & Ices InformationInformations FCC et Ices Supported Protocols Parts ListDescription System Overview POS terminal networkInstallation Mounting the BridgeCOM 1 RS232 connector Making Connections to the BridgeATM/POS Bridge Installation en RS232 Console RS485 COM Connector DetailPin Using the Bridge Detector Utility ConfigurationConfiguring the Bridge for a Network Connection Using the Direct Connection ATM/POS Bridge Configuration en Configuring Operation via a Network System MenuNetwork Setup En Configuration ATM/POS Bridge Terminal En Configuration ATM/POS Bridge COM Port Initiating a HyperTerminal Session Configuration Using HyperTerminalConnecting the Bridge ATM/POS Bridge Configuration Using HyperTerminal en Configuring Bridge Operation via HyperTerminal ATM/POS Bridge Configuration Using HyperTerminal en Communication Channels Terminal Setup En Configuration Using HyperTerminal ATM/POS Bridge Simulation Mode Recording LanguageService Menu Troubleshooting Technical Data EMC Updating Bridge Firmware ATM/POS Bridge 38 en ATM/POS Bridge ATM/POS Bridge 40 en ATM/POS Bridge Troubleshooting Bridge Firmware Update 42 en ATM/POS Bridge Page Bosch Security Systems, Inc