F. Install the Log Assembly | LOG PLACEMENT INSTRUCTIONS |
Log Set Assembly: LOGS-ESCAPE42
Models: Escape-42DV
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.
NOTE: If sooting occurs, the logs may need to be repositioned slightly to avoid excessive fl ame impinge- ment.
CAUTION: Logs are fragile! Carefully remove the logs from the packaging.
NOTE: If logs rub against one an- other during positioning, the white inner material may become visible.
Step 1.
NOTE: If bulb and orange lens are already installed, proceed to Step 2.
Remove the bulb from its packag- ing and locate the sockets installed in the square cut outs in the fi rebox
floor. The contacts on the bulb push into the two small holes in the socket top, as shown.
Place the framed orange lens on top of the fi rebox fl oor covering the bulb as shown. The four tabs on the lens frame go into the square cut out to help locate the lens.
6 | 3 | 5 | |
4 | |||
| |||
|
|
1
1 7 8
1 | 2 | 2 |
48 | Heat & Glo • |