ATM/POS Bridge | en 41 |
|
|
Troubleshooting Bridge Firmware Update
Use the following steps to correct the firmware settings If you receive the following error during the firmware update process:
1.Click OK to acknowledge the error.
2.Click the Cancel button to stop the process and to quite the wizard.
3.
4.Follow the process until you reach the communications setup wizard screen. Use the following values for the communication settings:
–Baud Rate: 19200
–Data: 8 bits
–Parity: None
–Stop: 1 bit
5.Continue through the wizard screens to start the upload process.
Bosch Security Systems, Inc. | Installation Manual | F.01U.171.816 1.0 2010.09 |