ATM/POS Bridge | en 37 |
|
|
a.Unplug the power cable from the bridge.
b.Connect the supplied console cable to COM Port 3 (console) on the bridge and to a COM port on the PC.
c.Connect the supplied power adapter to the bridge and to the main power.
The red LED light on top of the bridge flashes short pulses to indicate that the bridge is in download mode.
NOTICE!
if the console download cable is attached to the PC via a low- end USB to Serial adapter, the firmware download attempt may take several attempts before it succeeds. Bosch recommends the SIIG USB to Serial serial adapter, a
5.Click Next to select the PC COM port and to configure the bridge communication settings.
Change the settings for the Baud rate, Data, Parity, and
Stop parameters to match the settings on the PC.
Bosch Security Systems, Inc. | Installation Manual | F.01U.171.816 1.0 2010.09 |