Rackmount Solutions RP-W922QD of the Setup Menu Display Setting, Title setup, Dwell Time setup

11.5 Quad Display On-screen Menu Chapter 11

Right after the unit is turned on, The monitor will display the last setting on the Setup Menu.

1. Page 1 of the Setup Menu - Display Setting

Push Setup buttons (#1, #2) simultaneously to display the Setup Menu on the screen. There are total two pages in the Setup Menu. Page 1 is used to program TIME, DATE, and camera TITLE. Page 2 is used to program Alarm Operations. Under this mode, channel selection buttons (#5) on the front panel are used for cursor control and text selection. Use the cursor control buttons "<" and ">" to move the cursor to the location as desired to program, and use the text select but- tons " " and "" to choose the right alphanumeric character to program.

Page 1: Setting the TIME, DATE, TITLE, and DWELL time:

CH	TITLE	DWELL TIME
	QUAD	03S
1	CH 1	03 S
2	CH 2	03 S
3	CH 3	03 S
4	CH 4	03 S

LIVE VIDEO FREEZE		ON
VIDEO OUT:	LIVE	QUAD
TITLE:	ON	ON
TIME: 23 : 10 : 10	ON	ON
DATE: 12 - 25 - 2003	ON	ON

1.1 TITLE setup:

The Title menu permits the setup of separate titles for each video channel. 8 characters may be entered for each video channel. The available alphanumeric characters are:

0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D,..... X, Y, Z, . , :, - , / , < , > ,,, space ,

1.2 DWELL Time setup:

The Dwell time menu permits setting the dwell time for all cameras and the Quad Screen on the LIVE output channel. The menu shows a table of all cameras and associated dwell time. Dwell time can be programmed by setting a number between 00 to 99 for each channel in the menu.

■01 through 99: Adds the camera input to the auto switching SEQUENCE, with the corresponding dwell time in sec- onds.

■00: Skips the camera input in the auto switching SEQUENCE.

1.3 TIME/DATE setup:

Time and date information can be displayed on the video output channel through both LIVE and QUAD connector. Bot- tom of page 1 is used to set the values of time and date and also to enable or disable the display at each output channel.

The date and time will display in the “MM-DD-YYYY HH:MM:SS” format for NTSC model and “DD-MM-YYYY HH:MM:SS” format for PAL model.

1.4 TITLE/TIME/DATE disable and enable on LIVE and QUAD video output channel:

The Title/Time/Date display on each output channel can be enabled or disabled by setting ON or OFF in the correspond- ing entry.

P.37