3M MP8650 manual Now What?, Adjusting the Projector Elevation, Rear Projection

Adjusting the Projector Elevation

The elevation can be adjusted by turning the foot adjuster (Figure 3-12) to raise or lower the angle of the projector.

Figure 3-12. Foot Adjuster

nNote

Both adjusting feet must be raised or lowered the same amount to project a level image on the viewing screen. The elevation can be adjusted up to seven degrees.

Rear Projection

A semi-transparent screen (Figure 3-13) can be used to project an image and view it from the backside of the viewing screen. For this type of installation, the image must be inverted. Refer to section 4-6 Inverting the Image for more details.

Viewing
Side	90°

The projected light beam has an off-center ratio of 80% above and 20% below the center of the lens.

Figure 3-13. Rear Projection Viewing

3-3. Now What?

Your MP8650 is now connected and ready to power on. Turn to Section 4 for details on operating the projector.

10		Multimedia Projector MP8650	 3M 1997
	3M