H/V
Press once for horizontal (left/right) or press twice for vertical (up/down) position adjustment. The
LED on the remote control will flash. Press 
or 
to adjust the setting or press the RESET
button 
to return it to the factory default setting.
Using the Mouse Buttons
The PC serial cable or Apple Macintosh mouse receiver must be connected before the remote control buttons will operate the mouse functions. See RS232C Serial Cable/Mouse Receiver Connection in Section 3.
There are three mouse buttons
Mouse Stick: The mouse stick controls the position of the
L ± Left Mouse Button: This button has the same function as a left mouse button.
R ± Right Mouse Button: This button has the same function as a right mouse |
| |
button. Press and hold the R button to backlight all the buttons on the remote |
| |
control. After a few seconds, the backlighting will automatically turn off. | Figure | |
|
| |
DRAG: Use this button to hold and drop an object so it can be moved to a new |
| |
position on the screen. |
| |
a. | Press and release the DRAG button to select a highlighted object |
|
| (similar to pressing down and holding a normal mouse key button). |
|
b. | Use the mouse STICK to move the object to a new position. |
|
c. | Press the DRAG button again to release the object. |
|
Mouse Receiver ± (Apple Macintosh computer only)
Set the mouse receiver on top of the MP8650 projector with the sensor facing the projection screen. Point the remote control at the projection screen to bounce the signal off of the screen and back to the mouse receiver.
nNote
The mouse receiver must be positioned so that the remote control signal can enter the sensor. You can either bounce the signal off of the projection screen or rotate the mouse receiver to aim the remote directly at it. Aiming the remote directly at the receiver will increase the effective signal distance.
For best results, always use fresh batteries in the remote control transmitter.
Figure 5-3. Using the Remote Control
Replacing the Batteries
The remote control uses three AAA batteries. The battery cover is located on the back of the remote control (Figure
Figure 5-4. Replacing the Batteries
16 | | Multimedia Projector MP8650 | 3M 1997 |
3M |
|