3M MP8650 manual Technical Specifications, Video Input Signal Terminal

Section 9: Technical Specifications

9-1. Specifications

Width

Height

Depth

Weight Panel size

Number of pixels per panel Dot defect

Zoom lens

Metal halide lamp

Power supply

Power consumption Storage temperature range Operating temperature range Input terminals

Input signals

RGB (computer) input

Output terminals

Output signals

Batteries for remote control

28.1cm (10.95 inch)

35.6cm (13.88 inch)

48.6cm (18.95 inch) 14 kg (30.94 lbs)

8.1cm (3.2 inches)

480,000 pixels (H800 X V600), 3 panels = 1.44 million total pixels < 0.011% of total pixel count

1.6:1

350W, rated at 1000 hours to half brightness

(110V±user can replace lamp, 220V±lamp must be replaced at service center)

AC90-132V, 50/60Hz

AC170-260V, 50/60Hz Maximum 470W (typical) ±20°C to 60°C (±4°F to 140°F)

0°C to 35°C (32°F to 95°F) S-Video: Mini DIN4-pin terminal Video: RCA jack

Audio: RCA jack

Computer (RGB): D sub15-pin HD terminal

S-Video: Luminance 1.0V peak-to-peak , 75Ω termination Chroma 0.286V peak-to-peak (burst signal) 75Ω term.

Video: 1.0V peak-to-peak, 75Ω termination

Audio: 260mvRMS, across 46kΩ

Computer (RGB1/RGB2): 0~0.7V peak-to-peak, 75Ω

Audio: RCA jack

Computer (RGB): D sub15-pin HD terminal

Audio: RCA jack

Monitor: 0~0.7V peak-to-peak, 75Ω

Audio: 7V peak-to-peak or less, 680Ω termination Three AAA, 1.5 Volt

9-2. S-Video Input Signal Terminal

The following illustration (Figure 9-1) identifies the terminal connections for the Mini DIN4-pin.

Chrominance	Luminance
Signal
	Signal
Ground	Ground

Figure 9-1. S-Video Input (Mini DIN4-pin)

Video input signal terminals are detected by the MP8650 in the following order of priority:

DS-video input terminal

DRCA jack input terminal

20		Multimedia Projector MP8650	 3M 1997
	3M