LG Electronics HX300G, HX301G owner manual Installing and Composition, Installation Precautions

			Installing and Composition
Installing and Composition
	Installation Precautions
	Provide proper ventilation for this projector.
•	The projector is equipped with ventilation holes(intake) on	•	Do not place the projector on a carpet, rug or other similar
	the bottom and ventilation holes(exhaust) on the front. Do		surface. It may prevent a adequate ventilation of the pro-
	not block or place anything near these holes. Internal heat		jector bottom. This product should be mounted to a wall
	build-up may occur, causing picture degradation or dam-		or ceiling only.
	age to the projector.
•	Never push projector or spill any kind of liquid into the	•	Leave an adequate distance (30 cm or more) around the
	projector.		projector.

Place this projector in adequate temperature and humidity conditions.

•  Install this projector only in a location where adequate temperature and humidity is available. (refer page 42)

Don’t place the projector where it can be covered with dust.

•  This may cause overheating of the projector.

Do not obstruct the slots and openings of the projector. This may cause overheating and create a fire hazard.

This projector is manufactured using high-precision technology. You may, however, see tiny black points and/or bright points (red, blue or green) that continuously appear on the projector Screen. This is a normal result of the manufacturing process and does not indicate a malfunction.

To display DTV programs, it is necessary to purchase a DTV receiver (Set-top Box) and connect it to the projector.

The remote control may not work when a lamp equipped with electronic ballast or a three-wavelength lamp is installed. Replace those lamps with international standard products to use the remote control normally.

11