Safety Instructions
Safety Instructions
Please take note of the safety instructions to prevent any potential accident or misuse of the projector.
ꔈSafety Instructions are given in two forms as detailed below.
WARNING : The violation of this instruction may cause serious injuries and even death. 
NOTES : The violation of this instruction may cause injuries or damage to the projector.
ꔈAfter reading this manual, keep it in the place that you can access easily.
| Indoor Installation | WARNING |
|
|
|
Do not place the Projector in direct sunlight or near heat sources such as radiators, fires, stove etc.
This may cause a fire hazard!
Do not block the vents of the pro- jector or restrict
This would cause the internal tempera- ture to increase and could cause a fire hazard or damage to the unit!
Do not place flammable materi- als in, on or near the projector.
This may cause a fire hazard!
Do not place the projector close to sources of steam or oil such as a humidifier.
This may create a fire hazard or an electric shock hazard!
Do not hang on the installed projector.
It may cause the projector to fall, causing injury or death.
Do not place the projector where it might be exposed to dust.
This may cause a fire hazard or damage to the unit!
Do not use the projector in a damp place such as a bathroom where it is likely to get wet.
This may cause a fire or an electric shock hazard!
Do not place the projector direct- ly on a carpet, rug or place where ventilation is restricted.
This would cause its internal tempera- ture to increase and might create a fire hazard or damage the unit.
Ensure good ventilation around the projector. The distance between the projector and the wall should be more than 30 cm.
An excessive increase in its internal temperature may cause a fire hazard or damage to the unit!
| Indoor Installation | NOTES |
|
|
|
When installing the projector on a table, be careful not to place it near the edge.
The projector could fall causing injury and damage to the projector.
Only use a suitable stand.
Disconnect from the power sup- ply and remove all connections before moving, or cleaning.
Only use the projector on a level and stable surface.
It may fall and cause injury and/or damage to the unit.
| Power | WARNING |
|
|
|
Earth wire should be connected.
Ensure that you connect the earth ground wire to prevent possible electric shock (That is a Projector with a
If grounding methods are not possible, have a qualified electrician install a separate circuit breaker.
Do not try to ground the unit by connecting it to telephone wires, lightening rods, or gas pipes.
The power cord should be inserted fully into the power outlet to avoid a fire hazard!
This may cause a fire hazard or damage the unit.
Do not place heavy objects on the power cord.
This may cause a fire or an electric shock hazard!
4