ASSEMBLING AND PREPARING 9
Connecting the stand
- Only on some models.
1Place a soft cloth on the table and put the product with the screen facing downward. Connect the stand as shown in the following picture.
Using the IR Receiver
This allows a remote control sensor to be placed in a custom location. Then that display can control other displays via an
ENGLISH
2 Use the screws to secure the stand on the rear side of the product as shown in the diagram.
IR Receiver cable
NOTE
yyWhen you see from the back of the set, if the IR receiver cable does not face front, the signal reception range may shorten.
yyThe IR receiver is made with a magnet.It is detachable at the bottom (typical installation) or back (wall installation) of the set.