Onkyo SR804 instruction manual Controlling Other Components, Entering Remote Control Codes

Controlling Other Components

You can control your other components, including those made by other manufacturers, with the remote controller. This section explains how to:

•Enter the remote control code for a component that you want to control (e.g., DVD, TV, VCR).

•Learn commands directly from another component’s remote controller (see page 89).

•Program the MACRO buttons to perform a sequence of up to eight actions (see page 90).

Entering Remote Control Codes

2

REMOTE MODE

CD DVD

TV VCR

CABLE SAT

CDR MD

STANDBY

While holding down the REMOTE MODE button to which you want to enter the code, press the [STANDBY] button.

The Remote indicator lights up.

To control another component, you must first enter the appropriate remote control code to a REMOTE MODE button. You’ll need to enter a code for each component that you want to control.

							Remote
STANDBY							indicator
	ON	STANDBY
					TV
				I		INPUT	TV I
	V1		V2	V3
Number	1		2	3		+
	V4	MULTI CH		DVD		TV CH
	4		5	6		-
buttons
	CD	TAPE		TUNER
	7		8	9
	PHONO					TV VOL
	+10		0	CLEAR
	- - / - - - 10		11		12
	INPUT SELECTOR
		MACRO
	1		2	3		ZONE2
RECEIVER		REMOTE MODE
	RECEIVER	DVD		CD		HDD	REMOTE
	TAPE/AMP
	TV	VCR		CABLE		SAT	MODE
				CDR		MD
	DIMMER					SLEEP
			U	ME
			MEN		NU
		OP
		T
	+
	CH		ENTER			VOL
	DISC
	ALBUM
	-
	PREV	R			P
	CH	ET	URN		U
				SET
	DISPLAY					MUTING
	REC		PLAYLIST			RANDOM
		LISTENING MODE
	STEREO	SURR
	REPEAT	AUDIO		SUBTITLE		PLAY MODE
	PURE A	DIRECT		THX		ALLST
	TEST TONE	CH SEL		LEVEL		LEVEL
	OPEN/CLOSE VIDEO OFF
				L NIGHT		Re-EQ
			RC-620M

1	Look up the appropriate remote
	control code in the separate
	Remote Control Codes list.
	The codes are organized by category.

3			Within 30 seconds, use the num-
V1	V2	V3	ber buttons to enter the 4-digit
			remote control code.
1	2	3
V4	MULTI CH	DVD	The Remote indicator flashes twice.
4	5	6
CD	TAPE	TUNER
7	8	9

0

11

4	Press the REMOTE MODE button
	again to select the remote con-
	troller mode, point the remote
	controller at the component, and
	check the operation.
	If the remote controller doesn’t work as
	expected, and several remote codes are
	listed, try each one in turn and use the
	one that works best.

Notes:

•Remote control codes cannot be entered for the [RECEIVER] and [HDD] REMOTE MODE buttons.

•The remote control codes provided are correct at the time of printing, but are subject to change.

•The HDD remote mode can only be used with the Onkyo Remote Interactive Dock at this time.

•The [DVD] and [CD] REMOTE MODE buttons are preprogrammed for use with Onkyo DVD players and CD players respectively.

*To control another manufacturer’s CD recorder or MD recorder, enter the appropriate control code to the [CD] REMOTE MODE button.

86