Onkyo TX-SR805, TX-SR875 instruction manual Precautions, Power, FCC Information for User

Page 3

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal with- out the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user- serviceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild deter- gent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thin- ners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel let- tering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SEC- TION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

For North American model

Pressing the [STANDBY/ON] button to select Standby mode does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Never Touch this Unit with Wet Hands—Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

6.Handling Notes

If you need to transport this unit, use the original packaging to pack it how it was when you origi- nally bought it.

Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

This unit’s top and rear panels may get warm after prolonged use. This is normal.

If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

For U.S. models

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter- ference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV techni- cian for help.

For Canadian Models

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLEC- TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRE- SPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

3

Image 3
Contents TX-SR805 TX-SR875 Avis Important Safety InstructionsFCC Information for User PrecautionsPower For models having a power cord with a polarized plugFor British models PrecautionsContents Features THX Ultra2 Supplied AccessoriesMake sure you have the following accessories Power cordMultiroom Capability Main RoomZone 2 Room Zone 3 Room Front Panel Getting to Know the AV ReceiverGetting to Know the AV Receiver Display Rear Panel Front L/R, CENTER, Surr L/R, and Surr Back L/R Speakers Digital Coaxial in 1, 2,Digital Optical in 1, 2, and OUT GND screwRemote Controller Installing the BatteriesUsing the Remote Controller Remote Controller About the Remote Controller ModesRECEIVER/TAPE Mode Standby button Listening Mode buttonsRemote Mode buttons Tape modeDVD Mode CD/MD/CDR Modes Dock Mode Surround back left and right speakers Connecting Your SpeakersEnjoying Home Theater SubwooferConnecting Your Speakers Connecting Your SpeakersStrip about 5/8 Speaker Connection PrecautionsConnecting the Speaker Cables Fully insert the bare wireBi-amping Speaker Hookup Bi-amping the Front SpeakersBridged Speaker Hookup Bridging the Front Speakers TX-SR875 onlyAttach the FM antenna, as shown American Model Connecting AntennasConnecting the Indoor FM Antenna Connecting the AM Loop AntennaUsing a TV/FM Antenna Splitter Connecting AntennasConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaAV Connection Color Coding Connecting Your ComponentsAbout AV Connections Optical Digital JacksWhich Connections Should I Use? Connecting Your ComponentsConnecting Audio and Video Signals to the AV Receiver Hdmi Monitor Setting Set to YesAudio Connection Formats Hdmi Monitor Setting Set to NoTV, projector, etc Video Signal Flow Chart DVD player, etc Audio Signal Flow Chart DVD player, etcHint Connecting a TV or ProjectorVideo Connection Audio ConnectionOr the other Connecting a DVD playerDVD player Hooking Up the Multichannel InputVCR or DVR Connecting a VCR or DVR for PlaybackDigital Optical OUT Connecting a VCR or DVR for RecordingSatellite, cable, set-top box, etc About Copyright Protection Connecting Components with HdmiAbout Hdmi Supported Audio FormatsVideo Signals Audio SignalsMaking Hdmi Connections Game Console Connecting a Game ConsoleCamcorder, etc Connecting a Camcorder or Other AV ComponentCD player Connecting a CD PlayerConnecting a Turntable StepConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting a Power AmplifierPower amplifier European model Connecting an RI DockWork Connecting Onkyo ComponentsConnecting the Power Cord Malfunction Some components may not support all FunctionsTurning On and Standby Set the Power switch to the on positionDo the automatic speaker setup-this is essential Turning On the AV ReceiverSpeaker Settings First Time SetupAssign, and then press Enter First Time SetupHdmi Monitor Setup Buttons to select 1. Input/OutputPress the Hdmi OUT button Using the Hdmi OUT ButtonButtons to select Resolution Current setting is displayedOUT Hdmi Input SetupHdmi Input menu appears VersionFirst Time Setup Appears Component Video Input SetupAssign, and then press Input/Output Assign menuChanging the Input Display Input selector Audio input Digital Input SetupThese are the default assignments Digital Input menu appearsUsing the Digital Input Button Analog Input Setup Buttons to select an input selecTor 1st measurement position Automatic Speaker Setup Audyssey MultEQ XTUsing Audyssey MultEQ XT Measurement PositionsTurn on the AV receiver Place the setup microphone atConnect it to the Setup MIC When prompted, place the setupPlete, the following screen Error MessagesWhen the calculations are com Disconnect the setup micro PhoneOne of the surround speakers has not been detected Speaker Detect ErrorWriting Error One of the front speakers has not been detectedYou want to review, and then Changing the Speaker Settings ManuallyUsing a Powered Subwoofer Reviewing the ResultsButtons to select TV Format TV Format Setup Not North American modelsButtons to select 6. Miscella Neous, and then press EnterButtons to select AM Freq AM Frequency Step Setup on some modelsHardware Setup menu appears Buttons to select 7. HardwarePlaying Your AV Components SettingsSelect a listening mode and enjoy See Using the Listening Modes onTuning into AM/FM Radio Stations Listening to the RadioListening to AM/FM Stations Followed by the D.TUN button Tuning into Stations by FrequencyListening to the Radio Displaying AM/FM Radio InformationThis allows you to search RDS radio stations by type see Using RDS not North American modelWhat is RDS? RDS Program Types PTYDisplaying Radio Text RT Finding Stations by Type PTYListening to Traffic News TP Presetting AM/FM Stations Selecting PresetsDeleting Presets Muting the AV Receiver Adjusting Speaker LevelsSetting the Display Brightness Common FunctionsDisplaying Source Information Using the Sleep TimerUsing Headphones Common FunctionsSelecting Audio Inputs Specifying the Digital Signal Format Selecting on the AV Receiver Using the Listening ModesSelecting with the Remote Controller Selecting the Listening ModesUsing the Listening Modes Listening Modes Available for Each Source FormatAnalog and PCM Sources Sacd DSD, Dolby Digital, and Dolby Digital Plus SourcesDTS-ES TrueHD and DTS SourcesDTS-HD Sources DTS NEO6 Use this mode with any stereo movie e.g., TV, DVD, VHSAbout the Listening Modes Sound is output by the front left and right speakersDSD Onkyo Original DSP Modes Recording Recording the Input SourceRecording from Different AV Sources Submenu Onscreen Setup MenusMenu Map Main menuAdjusting the Listening Modes Using the Late Night FunctionUsing the Re-EQ Function Adjusting the Listening Modes Audio AdjustTone Control Settings Direct Setting Multiplex/Mono SettingsPLIIx/Neo6 Settings LFE Level Settings Listening Mode PresetsDolby Digital Settings Theater-Dimensional SettingAudio formats supported by that input selector appear Buttons to select Subwoofer Advanced SetupSpeaker Setup Speaker SettingsCrossover frequency Advanced SetupLow-Pass Filter for the LFE Channel Double BassButtons to select Double Bass Speaker Distance Speaker Level Calibration Equalizer Settings THX Audio Setup Source Setup Buttons to select THX SubWoofer, and use the Left You want to give a custom name IntelliVolumeName Edit SyncArrow Buttons To display the following screen When you’ve finished, useSatellite Radio Sirius Parental LockMaximum Volume Miscellaneous SetupVolume Setup Volume DisplayOSD Setup Hardware Setup Remote ControlZone 2 and Zone Analog Multich Lock Setup 100Lock Zone 2 and Zone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Connecting Your Zone 2 Speakers to an Amp in ZoneZone 2 Video Output TX-SR875 only Connecting Your Zone 3 Speakers102 Zone 2 and Zone103 Powered Zone 2 SettingZone 2/Zone 3 Out Settings Using Zone 2 and Zone104 Turning Off Zones On the remote controller, press105 Selecting an Input Source for Zones106 Adjusting the Volume of Zones Muting ZonesAdjusting the Tone of Zone Adjusting the Balance of Zones107 Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with a Cabinet Using a Multiroom Kit with Other ComponentsEntering Remote Control Codes Controlling Other Components108 109 Resetting the Remote ControllerRemote Control Codes for Onkyo Components Connected via Resetting the Remote Mode ButtonsEject 110CH +/-, TV CH + CH +111 Learning CommandsRunning Macros Using Macros112 Making Macros113 Troubleshooting114 Troubleshooting115 116 117 SpecificationsControl Terminal 118Specifications Audio OutputsMemo Onkyo Europe UK Office 120Onkyo U.S.A. Corporation Onkyo Europe Electronics GmbH

TX-SR805, TX-SR875 specifications

The Onkyo TX-SR875 and TX-SR805 are both powerful AV receivers that have garnered attention for their impressive sound quality and robust feature sets. These models are designed to meet the needs of home theater enthusiasts looking for high-performance audio and video experiences.

The TX-SR875 is a 7.1-channel network AV receiver known for its ability to deliver breathtaking audio fidelity. One of its standout features is its HD Theater 3D processing, which utilizes advanced surround sound algorithms to create a genuinely immersive listening experience. The receiver supports various audio formats, including Dolby TrueHD and DTS-HD Master Audio, which are essential for modern Blu-ray and streaming services that aim to provide high-resolution sound.

In addition to its audio prowess, the TX-SR875 features a user-friendly on-screen interface, making navigation through various settings and configurations straightforward. The inclusion of HDMI 1.3a inputs ensures compatibility with the latest video sources, allowing for full 1080p video pass-through. Furthermore, the receiver's Faroudja DCDi technology enhances video quality by reducing artifacts and improving upscaling for standard-definition content.

The TX-SR805 is slightly more streamlined but still boasts impressive capabilities. This 7.1-channel receiver shares many similarities with the TX-SR875, including support for high-definition audio formats and HDMI connectivity. However, it focuses more on providing essential features at a more accessible price point. The TX-SR805 features the same audio processing technologies as its higher-end counterpart, ensuring a quality listening experience with support for multi-channel surround sound.

Both receivers are equipped with Onkyo's proprietary Advanced Music Optimizer technology, which enhances compressed audio files, offering improved sound quality from MP3s or streaming services. The receivers also come with Audyssey MultiEQ technology, which automatically calibrates speaker settings based on your specific room acoustics, ensuring optimal sound quality tailored to your home environment.

In summary, the Onkyo TX-SR875 and TX-SR805 AV receivers deliver high-quality audio and video performance, making them excellent choices for home theater setups. Their combination of cutting-edge processing technologies, multiple audio format support, and user-friendly features set them apart in the competitive landscape of AV receivers. Whether you choose the TX-SR875 for its premium features or the TX-SR805 for its value-oriented offerings, both models promise a superior home entertainment experience.