Onkyo TX-SR875, TX-SR805 instruction manual Speaker Level Calibration

Page 90

Advanced Setup—Continued

Speaker Level Calibration

These settings are set automatically by the Automatic Speaker Setup function (see page 55).

With the Level Calibration settings, you can adjust the level of each speaker while listening to the test tone so that the volume of each speaker is the same at the listen- ing position.

Note:

• The test tone is output at the standard level for THX,

which is 0 dB (absolute volume setting 82). If you nor-

mally listen at volume settings below this, be careful

because the test tone will be much louder.

3

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “4. Level Cali- bration,” and then press [ENTER].

The Level Calibration screen appears and the pink noise test tone is output by the front left speaker.

2-4.Level Calibration

Left

 

-12.0dB

Center

 

-12.0dB

Right

 

-12.0dB

Surr Right

 

-12.0dB

Surr Back R

 

-12.0dB

Surr Back L

 

-12.0dB

Surr Left

 

-12.0dB

Subwoofer

 

-15.0dB

1

Press the [RECEIVER] REMOTE

MODE button, followed by the

 

RECEIVER

[SETUP] button.

The main menu appears onscreen.

SETUP

Note:

•Levels cannot be adjusted for speak- ers set to No or None in the Speaker Configuration (page 86).

4

 

Use the Up and Down [

]/[

]

 

buttons to select a speaker, and

 

 

 

 

use the Left and Right [

]/[

]

 

ENTER

buttons to adjust the level.

 

 

 

 

 

 

Levels can be adjusted from –12 to

 

 

 

+12 dB in 0.5 dB steps (–15 to +12 dB

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “2. Speaker Setup,” and then press [ENTER].

The Speaker Setup menu appears.

2.Speaker Setup

1.Speaker Settings 2.Speaker Config 3.Speaker Distance 4.Level Calibration 5.Equalizer Settings 6.THX Audio Setup

 

for the subwoofer).

 

 

5

Repeat step 4 for each speaker

so that the volume of the test

 

 

tone from each speaker is the

 

same.

 

If you’re using a handheld sound level

 

meter, adjust the level of each speaker

 

so that it reads 75 dB SPL at the listen-

 

ing position, measured with C-weight-

 

ing and slow reading.

 

 

6

Press the [SETUP] button.

Setup closes.

 

 

S

 

E

 

T

 

UP

Note:

•Speaker levels can also be adjusted by using the dedi- cated buttons on the remote controller. Press the [TEST TONE] button to output the test tone. Use the [CH SEL] button to select each speaker, and use the

[LEVEL–] and [LEVEL+] buttons to adjust the level.

90

Page 89 Page 91
Image 90
Page 89 Page 91
Contents
TX-SR805 TX-SR875 Important Safety Instructions AvisFor models having a power cord with a polarized plug PrecautionsPower FCC Information for UserPrecautions For British modelsContents Features Power cord Supplied AccessoriesMake sure you have the following accessories THX Ultra2Multiroom Capability Main RoomZone 2 Room Zone 3 Room Getting to Know the AV Receiver Front PanelGetting to Know the AV Receiver Display Rear Panel GND screw Digital Coaxial in 1, 2,Digital Optical in 1, 2, and OUT Front L/R, CENTER, Surr L/R, and Surr Back L/R SpeakersRemote Controller Installing the BatteriesUsing the Remote Controller Remote Controller About the Remote Controller ModesRECEIVER/TAPE Mode Tape mode Listening Mode buttonsRemote Mode buttons Standby buttonDVD Mode CD/MD/CDR Modes Dock Mode Subwoofer Connecting Your SpeakersEnjoying Home Theater Surround back left and right speakersConnecting Your Speakers Connecting Your SpeakersFully insert the bare wire Speaker Connection PrecautionsConnecting the Speaker Cables Strip about 5/8Bi-amping the Front Speakers Bi-amping Speaker HookupBridging the Front Speakers TX-SR875 only Bridged Speaker HookupConnecting the AM Loop Antenna Connecting AntennasConnecting the Indoor FM Antenna Attach the FM antenna, as shown American ModelConnecting an Outdoor AM Antenna Connecting AntennasConnecting an Outdoor FM Antenna Using a TV/FM Antenna SplitterOptical Digital Jacks Connecting Your ComponentsAbout AV Connections AV Connection Color CodingHdmi Monitor Setting Set to Yes Connecting Your ComponentsConnecting Audio and Video Signals to the AV Receiver Which Connections Should I Use?Audio Signal Flow Chart DVD player, etc Hdmi Monitor Setting Set to NoTV, projector, etc Video Signal Flow Chart DVD player, etc Audio Connection FormatsAudio Connection Connecting a TV or ProjectorVideo Connection HintConnecting a DVD player Or the otherHooking Up the Multichannel Input DVD playerConnecting a VCR or DVR for Playback VCR or DVRConnecting a VCR or DVR for Recording Digital Optical OUTSatellite, cable, set-top box, etc Supported Audio Formats Connecting Components with HdmiAbout Hdmi About Copyright ProtectionVideo Signals Audio SignalsMaking Hdmi Connections Connecting a Game Console Game ConsoleConnecting a Camcorder or Other AV Component Camcorder, etcStep Connecting a CD PlayerConnecting a Turntable CD playerConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting a Power AmplifierPower amplifier Connecting an RI Dock European modelMalfunction Some components may not support all Functions Connecting Onkyo ComponentsConnecting the Power Cord WorkTurning On the AV Receiver Set the Power switch to the on positionDo the automatic speaker setup-this is essential Turning On and StandbyFirst Time Setup Speaker SettingsButtons to select 1. Input/Output First Time SetupHdmi Monitor Setup Assign, and then press EnterCurrent setting is displayed Using the Hdmi OUT ButtonButtons to select Resolution Press the Hdmi OUT buttonVersion Hdmi Input SetupHdmi Input menu appears OUTFirst Time Setup Input/Output Assign menu Component Video Input SetupAssign, and then press AppearsChanging the Input Display Digital Input menu appears Digital Input SetupThese are the default assignments Input selector Audio inputUsing the Digital Input Button Analog Input Setup Buttons to select an input selecTor Measurement Positions Automatic Speaker Setup Audyssey MultEQ XTUsing Audyssey MultEQ XT 1st measurement positionWhen prompted, place the setup Place the setup microphone atConnect it to the Setup MIC Turn on the AV receiverDisconnect the setup micro Phone Error MessagesWhen the calculations are com Plete, the following screenOne of the front speakers has not been detected Speaker Detect ErrorWriting Error One of the surround speakers has not been detectedReviewing the Results Changing the Speaker Settings ManuallyUsing a Powered Subwoofer You want to review, and thenNeous, and then press Enter TV Format Setup Not North American modelsButtons to select 6. Miscella Buttons to select TV FormatButtons to select 7. Hardware AM Frequency Step Setup on some modelsHardware Setup menu appears Buttons to select AM FreqSee Using the Listening Modes on SettingsSelect a listening mode and enjoy Playing Your AV ComponentsTuning into AM/FM Radio Stations Listening to the RadioListening to AM/FM Stations Displaying AM/FM Radio Information Tuning into Stations by FrequencyListening to the Radio Followed by the D.TUN buttonRDS Program Types PTY Using RDS not North American modelWhat is RDS? This allows you to search RDS radio stations by type seeDisplaying Radio Text RT Finding Stations by Type PTYListening to Traffic News TP Presetting AM/FM Stations Selecting PresetsDeleting Presets Common Functions Adjusting Speaker LevelsSetting the Display Brightness Muting the AV ReceiverCommon Functions Using the Sleep TimerUsing Headphones Displaying Source InformationSelecting Audio Inputs Specifying the Digital Signal Format Selecting the Listening Modes Using the Listening ModesSelecting with the Remote Controller Selecting on the AV ReceiverUsing the Listening Modes Listening Modes Available for Each Source FormatAnalog and PCM Sources DSD, Dolby Digital, and Dolby Digital Plus Sources SacdTrueHD and DTS Sources DTS-ESDTS-HD Sources Sound is output by the front left and right speakers Use this mode with any stereo movie e.g., TV, DVD, VHSAbout the Listening Modes DTS NEO6DSD Onkyo Original DSP Modes Recording Recording the Input SourceRecording from Different AV Sources Main menu Onscreen Setup MenusMenu Map SubmenuAdjusting the Listening Modes Using the Late Night FunctionUsing the Re-EQ Function Adjusting the Listening Modes Audio AdjustTone Control Settings Direct Setting Multiplex/Mono SettingsPLIIx/Neo6 Settings Theater-Dimensional Setting Listening Mode PresetsDolby Digital Settings LFE Level SettingsAudio formats supported by that input selector appear Speaker Settings Advanced Setup Speaker Setup Buttons to select SubwooferAdvanced Setup Crossover frequencyLow-Pass Filter for the LFE Channel Double BassButtons to select Double Bass Speaker Distance Speaker Level Calibration Equalizer Settings THX Audio Setup Source Setup Buttons to select THX SubWoofer, and use the Left Sync IntelliVolumeName Edit You want to give a custom nameSirius Parental Lock When you’ve finished, useSatellite Radio Arrow Buttons To display the following screenVolume Display Miscellaneous SetupVolume Setup Maximum VolumeOSD Setup Hardware Setup Remote ControlZone 2 and Zone Analog Multich Lock Setup 100Lock Connecting Your Zone 2 Speakers to an Amp in Zone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Zone 2 and ZoneZone 2 and Zone Connecting Your Zone 3 Speakers102 Zone 2 Video Output TX-SR875 onlyPowered Zone 2 Setting 103Zone 2/Zone 3 Out Settings Using Zone 2 and Zone104 Selecting an Input Source for Zones On the remote controller, press105 Turning Off ZonesAdjusting the Balance of Zones Adjusting the Volume of Zones Muting ZonesAdjusting the Tone of Zone 106Using a Multiroom Kit with Other Components Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with a Cabinet 107Entering Remote Control Codes Controlling Other Components108 Resetting the Remote Mode Buttons Resetting the Remote ControllerRemote Control Codes for Onkyo Components Connected via 109CH + 110CH +/-, TV CH + EjectLearning Commands 111Making Macros Using Macros112 Running MacrosTroubleshooting 113Troubleshooting 114115 116 Specifications 117Audio Outputs 118Specifications Control TerminalMemo Onkyo Europe Electronics GmbH 120Onkyo U.S.A. Corporation Onkyo Europe UK Office
Top Page Image Contents