LG Electronics MT-50PZ40, MT-50PZ41, MT-50PZ43S, MZ-50PZ42, MZ-50PZ43 Turning on the Monitor

Page 14

Turning on the Monitor

- When using the remote control, aim it at its sensor on the Monitor.

Turning on the Monitor just after installation

1.Connect power cord correctly.

2.Press the ON/OFF button on the Monitor. At this moment, the Monitor is switched to standby mode. Press the INPUT SELECT button on the Monitor or press the POWER, INPUT SELECT button on the remote control and then the Monitor will be switched on.

Turning on the Monitor (power cord is still connected)

1.If the Monitor is turned off with the ON/OFF button on the Monitor

Press the ON/OFF button on the Monitor to turn on the Monitor.

2.If the Monitor is turned off with the remote control and also the ON/OFF button on the Monitor

Press the ON/OFF button on the Monitor and then press the INPUT SELECT button on the Monitor or press the POWER, INPUT SELECT button on the remote control to turn on the Monitor.

Adjusting volume level

Volume(G) button increases the level of sound and volume(F) button decreases the level of sound.

Menu language setup

-The menu can be displayed on the screen in desired language. First select your language.

1.Press the MENU button and then D / E button to select the SPECIAL menu.

2..Press the G button and then D / E button to select Language.

3.Press the G button and then D / E button to select your desired language. From this point on, the on-screen display will be presented in the language of your choice.

4.Press the MENU button.

14

Image 14
Contents Plasma Monitor LG Plasma Monitor Contents Earth wire should be connected Safety InstructionsDo not use water the Monitor while cleaning Do not insert any object into the exhaust ventOnly use the specified batteries Do not pull the cord but the plug when unpluggingObjects like a heater Back Panel Controls of the MonitorFront Panel Controls Scart Type Watching External EquipmentsBack Panel RCA Type External Speaker 8 ohm outputWatching DVD When the Interface board is installed Watching VCR When the Interface board is installedWatching Cable TV When the Interface board is installed How to connectPC Setup Connecting PCSetup Instructions to Connect a PC to your Monitor Resolution Horizontal Vertical Displayable Monitor SpecificationRGB1 mode Resolution Horizontal Vertical RGB2 mode Resolution Horizontal VerticalControls of the remote control Installing BatteriesAccessories Optional ExtrasTo install as desktop type Monitor InstallationTo install as wall mounting type Turning on the Monitor power cord is still connected Menu language setupTurning on the Monitor just after installation Adjusting volume levelVideo Menu Adjusting Auto Colour ControlManual Colour Temperature ControlUser option PSM Picture Status MemoryPress the SSM button to select the picture appearance setup AVL Auto Volume LevelerAdjusting Sound Manual Setting Audio MenuSleep Timer Setting the ClockSetting the On/Off Timer Time MenuOrbiter Special MenuChild lock White WashScreen Menu Auto adjustment RGB1PC mode onlySetting Picture Format Split ZoomScreen Position Manual Configure RGB1PC mode onlyInitializing Reset to factory value PIP Function Selecting a source for the Twin picture Sub Picture Size AdjustmentTwin Picture Swapping the Twin PictureRS-232C configurations External Control Device SetupType of connector D-Sub 9-pin male Set IDInput select Commandb Main picture input Command Reference ListPower Commanda Transmission / Receiving ProtocolVolume mute Commande Aspect Ratio Commandc Main picture formatScreen mute Commandd Volume control CommandfOSD select Commandl Sharpness CommandkPIP Size Commando Remote control lock mode CommandmRed Adjustment Commandv Balance CommandtColour temperature Commandu Green Adjustment CommandwReal data mapping 1 0 Step Orbiter Time Setting CommandrOrbiter Pixel Setting Commands Real data mappingPage No sound Troubleshooting check listNo picture No output from oneProduct specifications Model