Mitsubishi Electronics XL5980LU user manual Procedure for setting the Anti-Theft Alarm device

About the terminal cover (with Anti-Theft Alarm device)

This projector includes a terminal cover with Anti- Theft Alarm device. Once the terminal cover is installed, its Anti-Theft Alarm device will detect vibration caused by the projector being moved and emit an alarm.

•Mitsubishi assumes no responsibility or liability for theft or other damages.

Procedure for setting the Anti-Theft Alarm device

Insert dry cell batteries into the theft warning device

1.Open the battery cover of the theft warning device.

2.Check the (+) and (-) ends of the battery, and insert it from the (-) end first.

Battery cover

Power switch

ON

•Inserting the battery from the (+) end makes it difficult to fit the (-) end into the coil spring. Forcing in the battery in such a position may shred the outside label, causing a short circuit and overheating.

•Please refer to page 8 for information on how to handle dry cell batteries.

3. Close the battery cover.

safety pin hole

safety pin Screws

4.Insert the included safety pin into the safety pin hole.

•If the safety pin is not inserted, the vibrations and shocks of normal use may cause the alarm to sound.

5. Turn the power switch ON.

Install the terminal cover

1.Insert the four tabs on the terminal cover into the holes on the projector’s side.

2.Slide the terminal cover toward the back of the projector.

Tabs

3.Tighten the three screws that keep the terminal cover in place.

4.Install the projector in a specified location.

5.Press the battery level check button until you hear a buzzer sound.

6.Remove the safety pin.

The Anti-Theft Alarm device is now in standby.

•This package includes a sticker which shows that the Anti-Theft Alarm device is active. Visible placement of this sticker is recommended.

•To temporarily halt the Anti-Theft Alarm device, insert the safety pin.

•Vibrations will not cause the alarm to sound for several seconds after the power switch is turned ON.

•Vibrations will not cause the alarm to sound for several seconds after the safety pin is removed.

•Vibrations and shocks from earthquakes may cause the alarm to sound. In such situations, insert the safety pin to halt the alarm.

•Batteries may come loose during transportation. Please remove them beforehand.

Procedure for changing batteries

How to check battery level

Use a pointed object to push the battery level check button.

battery level check button.

•A buzzer will sound while the button is being pushed. If there is no buzzer sound, then batteries need to be changed.

•Sounding the buzzer for a long time will consume battery power.

Change the dry cell batteries

1.Insert the safety pin into the safety pin hole.

2.Loosen the three screws that keep the terminal cover in place.

3.Slide the terminal cover toward the front of the projector.

4.Pull the terminal cover toward you and remove it.

• Attention must be paid when removing the terminal cover as there could be foreign objects inside.

• Removal of dust found inside the terminal cover is recommended when changing batteries.

5.Open the battery cover and remove the old dry cell batteries.

6.Check the (+) and (-) ends of the new battery, and insert it from the (-) end first.

•Use alkaline AA batteries.

•Standard battery life is approx. six months (when

using alkaline dry cell batteries). Please check the battery level and change batteries regularly.

7. Close the battery cover.

EN – 24