Mitsubishi Electronics DX-VS1 user manual LEDs of Ethernet port, Description of DIP Switches

Page 9

3) LEDs of Ethernet port

Yellow LED: This LED indicates the status of data transmission. After power is supplied, it is on for the first 4-5 seconds and then it goes off. And it blinks continuously when a user access DX- VS1UE and DX-VS1UE transmits data.

Green LED: This LED indicates the status of networking. After power is supplied, it is on for the first 1-2 seconds, and then it blinks once at every one second as long as the network is connected.

Diagnostic information on failure using LED

Problem on Network

•Green LED blinks once every 4 seconds.

Check that ethernet cable is connected properly and network has no problem.

Problem on Hardware

•Neither Yellow LED nor Green LED light up at all.

Since DX-VS1UE is in unstable operation, restart DX-VS1 by supplying power again.

If DX-VS1UE would not restore regardless of restarting, stop using and contact with store.

4) Description of DIP Switches

This is used to designate video signal termination. If you want to monitor real time image through a CCTV monitor as well as DX-VS1UE, connect a digital recorder to ‘Video Input’ connector and a CCTV monitor to ‘Video Output’ connector. In this case, the terminal of video signal need setting properly.

If you connect a digital recorder to ‘Video Input’ and monitor real time video only through a PC, place the left-hand side DIP switch at upper po- sition ‘ON’ (the side of ‘75ohm’).

8

DX-VS1UE User’s Manual

Page 8 Page 10
Image 9
Page 8 Page 10
Contents DX-VS1 Table of Contents DX-VS1UE User’s Manual Features What is DX-VS1UE?For DX-VS1UE For PC to access DX-VS1UEDescription Amount Remarks Confirmation of the AccessoriesDX-VS1UE View and Description Front View and Description Connector RemarksPTZ/DVR/COM Rear View and Description Connector name RemarksLEDs of Ethernet port Description of DIP SwitchesRight-hand side DIP swith is not available ・Connecting DX-VS1UE with PC Installation SummaryDX-VS1UE User’s Manual DX-VS1UE User’s Manual ・The circuit diagram of a sensor terminal Assigning IP Address and setting Administrator Condition Installing DX-VS1UE Setup ProgramMAC Address Media Access Control Address ・Setting Administrator ConditionsIP Address Crossover CableConnecting a digital recorder to DX-VS1UE Connecting BNC cableConnecting RS-232C cable PTZ/DVR/CO Composition of a screen Starting Web browserDVR Mail Event Configuration Application ConfigurationCheck E-Mail Options FTP directory configuration Check Points for E-mail Sending ProblemPan/tilt/zoom Configuration FTP event configurationTransmission Performance of E-mail and FTP Select Serial PortNew Group New PresetMode Configuration Manual Setting Serial Port ConfigurationSerial Port Selection Select Attached DevicePTZ Command for Manual Script Device Type for Input Ports Alarm Parameters for E-mail / FTP ApplicationCurrent State for Input Ports Motion Detection ThresholdWeb Server TCP Port Alarm PresetVideo Server TCP Port CustomizingLogin Page Editing When the changed settings are reflected?Hardware Detailed Specifications of DX-VS1UEVideo and Compression NetworkMisc functions and I/O Serial connection with digital recorder Frequently Asked Questions Installation and operation of DX-VS1UE DX-VS1UE User’s Manual DX-VS1UE User’s Manual DX-VS1UE User’s Manual
Top Page Image Contents