A c t i v a t i n g t h e p o w e r s a v i n g f u n c t i o n
This function operates only with an RGB input source.
If there are no input signals from the RGB IN connector for more than five minutes, the unit will automatically turn off and enter the standby mode.
1Press MENU to display the main menu.
2Press the cursor 
/
keys to select “POWER MENU.”
3Press
4Press the cursor 
/
keys to select “POWER OFF,” then press the cursor + key to select “ON” to activate the power saving function.
To deactivate the function, set “POWER OFF” to “OFF” by pressing the cursor – key.
A c t i v a t i n g t h e o n – s c r e e n f u n c t i o n
The factory setting of this function is “ON.”
When the function is activated, the source menu appears on the screen in the following cases:
•The source menu appears for three seconds when you select the input source with the remote control, and
•The source menu appears for approximately twenty seconds when you turn on the unit.
1Press MENU to display the main menu.
2Press the cursor 
/
keys to select “SETTING MENU.”
3Press
4Press the cursor 
/
keys to select “DISPLAY,” then press the cursor + key to select “ON” to activate the on- screen function.
To deactivate the function, set “DISPLAY” to “OFF” by pressing the cursor – key.
Q u i c k - s t a r t i n g t h e u n i t
The unit can be turned on by only connecting the power cable (see page 15) if you set “AUTO START” to “ON.” There is no need to press POWER ON on the remote control or POWER on the unit after “AUTO START” is activated to turn on the unit.
1Press MENU to display the main menu.
2Press the cursor 
/
keys to select “POWER MENU.”
3Press
4Press the cursor 
/
keys to select “AUTO START,” then press the cursor + key to select “ON” to activate the function.
To deactivate the function, set “AUTO START” to “OFF” by pressing the cursor – key.
E – 29