PLUS Vision U2-1130/U2-1110 E p a r i n g t h e M o t e c o n t r o l, Inserting the batteries

Page 7

For video equipment connection

Audio video cable	S-video cable
(1 m/3.3 ft.) [1]	(1 m/3.3 ft.) [1]

Lens cap (attached to the lens of the unit) [1]

About the lens cap

The lens cap is fixed on the bottom of the unit as shown in the illustration below.

Carrying case [1]

How to use the carrying case

Packing the unit

Packing the accesories

P r e p a r i n g t h e

r e m o t e c o n t r o l

Inserting the batteries

1 Press firmly and slide the battery cover off.

2 Insert the two supplied batteries (size AA/R6). Ensure that the polarities (+ and –) of the batteries are aligned correctly.

3 Slide the cover back until it snaps into place.

Notes

•If the remote control gets wet, wipe it dry immediately.

•Avoid excessive heat and humidity.

•If you will not be using the remote control for a long time, remove the batteries.

•Do not mix new and old or different types of batteries.

•There are operations that can only be carried out by remote control. Handle the remote control carefully.

Remote control effective range

The remote sensors are located on the front and back of the unit.

The controllable range is 50 degrees horizontally and 30 degrees vertically relative to a line that is at a right angle to the remote sensor. And the distance between the point of the remote control and remote sensor must be shorter than four meters (13 feet).

MOUSE

RGB IN

PC AUDIO	S-VIDEO

VIDEO	AUDIO
	L/MONO	R

	USER’S MANUAL	Quick Start Guide [1]
	(this manual) [1]	Quick Start Guide [1]
	(this manual) [1]

30˚ 50˚

50˚

30˚

E – 5

Image 7

Contents U2-1130/U2-1110 Plus Corporation U2-1130/U2-1110 English Power Supply PrecautionsImportant Safeguards InstallationB l e o f c o n t e n t s Serial mouse cable Mouse adapter For IBM PS/2 Power cable mains lead 1.8 m/5.9 ftA t u r e s E c k i n g t h e P p l i e d a c c e s s o r i e sE p a r i n g t h e M o t e c o n t r o l Remote control effective rangeInserting the batteries Menu button RGB in connectorR t s a n d c o n t r o l s Top, front and side panel viewBuilt-in Security Slot Lamp cover securing screw Rear adjusterRear and side panel view BottomFreeze button Mute button Click button 14Screen InstallationPositioning the unit Projecting distance and image sizeUsing the ceiling mounting fixtures Installation c o n t i n u e dN n e c t i o n s Units terminal panelConnector Before connectingN n e c t i n g a P C o r M a c i n t o s h 3 4 5 Modifying the DIP switch setting for MacintoshHow to connect to the IBM PS/2 or Macintosh computer How does the remote control operate the computer?Connecting the computer to the Mouse connector of the unit How to connect to the IBM PC/AT computerView from the top Adjust the position and height of the unitI n g t h e u n i t Before startingThen adjust the focus with the focus ring Adjust the image size with the zoom ringI n g t h e u n i t c o n t i n u e d Amber After using the unitWindows Windows 98/WindowsMacintosh Freezing a moving picture Adjusting the volume of the units speakerUsing the laser pointer Turning off the image and muting the sound temporarilyPress Magnify Enlarging the picturePress Pointer Press Magnify +Pointer N u s t r u c t u r e When the input source is Video or S-VIDEOOperating using the unit L e c t i n g t h e c o l o r s y s t e m R r e c t i n g t h e Y s t o n i n g e f f e c tL e c t i n g a m e n u l a n g u a g e L e c t i n g a O j e c t i o n t y p eL e c t i n g t h e b a c k g r o u n d L e c t i n g t h e p o i n t e r t y p eJ u s t i n g t h e v o l u m e Timing Chart Adjusting the clock phase Setting the input source to RGBSetting Auto Mode to OFF for manual ad- justment Adjusting the clock frequencyL e c t i n g t h e p i c t u r e t y p e J u s t i n g t h e C t u r e e l e m e n t sT i v a t i n g t h e o n s c r e e n f u n c t i o n T i v a t i n g t h e p o w e r s a v i n g f u n c t i o nI c k s t a r t i n g t h e u n i t E c k i n g h o u r s o f l a m p u s a g e Resetting the lamp usage hours to zeroS e t t i n g t o t h e f a c t o r y s e t t i n g s Common Problems & Solutions TroubleshootingStatus Light Messages Status indicatorP l a c i n g t h e l a m p c a r t r i d g e Lamp cartridge replacement procedureStep Optical Specification sPC 15-Pin mini D-Sub Sub Pin AssignmentsU2-1130 DimensionsU2-1110 Plus Corporation