Selecting a sound source

POWER	SLEEP	DIMMER	SUR	MULTI-CH
POWER	SLEEP	DIMMER	MODE	INPUT
	INPUT SELECTOR
DVD	TAPE	TUNER	PHONO	C D
VIDEO-1	VIDEO-2		PRESET
		TUNER
C D		DVD
DISC				MULTI-CH
				INPUT
TAPE		CH SEL	TEST
			TONE
		LEVEL	MUTING	VOLUME

LEFT			CENTER		RIGHT
SUBWOOFER				L-SUR	R-SUR
POWER			SUR	MULTI-CH	CH SEL
POWER	SLEEP	DIMMER	MODE	INPUT	TEST
DVD	TAPE	TUNER	PHONO	C D	TEST
	INPUT SELECTOR				TONE
VIDEO-1	VIDEO-2		PRESET		TONE
		TUNER
C D		DVD
DISC
TAPE		CH SEL	TEST
		CH SEL	TEST
			TONE
		LEVEL	MUTING	VOLUME	LEVEL

1				MASTER VOLUME
			N	U
	O	W	N	P
D	O	W
D

2 PARAMETER SELECTOR

PARAMETER CONTROLLER

PARAMETER SELECTOR

PARAMETER CONTROLLER

When Multi channel input is selected as a source

Follow the steps below to adjust the level of each speaker if you have selected MULTI CH INPUT.

1.Press MULTI CH INPUT button on the remote controller. You cannot select any Surround mode.

2.Press the CH SEL button to select the desired speakers.

3.Use the LEVEL π/† button to change the volume level of the speakers.

You can adjust the volume level of each speaker individually. Adjust the level while listening to the sound in the listening position.

You can adjust the level of the front, center, and surround speak- ers in the range between –12dB and +12dB.

You can adjust the subwoofer level in the range between –30dB and +12dB.

Note

•If the speaker level is set to +1dB or higher, the maximum level indicated on the display will change if you raise the volume level.

Using the Power On Volume function

This function automatically selects the volume level you set last time.

Follow the steps below:

1.Use the VOLUME control to set the desired level.

2.Press the PARAMETER SELECTOR √ or ® button repeatedly to display the “PWR ON VOL” parameter.

The current setting (ON or OFF) appears.

3.Press the PARAMETER CONTROLLER √ or ® button to select “ON.”

Even if the parameter has already been set to ON, turn it OFF, then turn it ON again to enable the Power On Volume function. The original display appears and the setting is completed. When you turn on the power to the unit next time, it will use the vol- ume level you set in step 1.

Note:

If the PWR ON VOL parameter is set to OFF, the Power On Vol- ume function is disabled. In this case, when you turn on the power to the unit next time, it will use the volume level that was set when you turned off the power.