Onkyo TX-DS484 instruction manual Video equipment connections, Digital audio connections

Video equipment connections

•On each pair of input jacks, a red connector (marked R) corresponds to the right channel, and a white connector (marked L) to the left channel.

•A yellow connector (marked V) is used for video connection.

•Please refer to the instruction manual of each component when making any con- nections.

Audio connection cable	L
L (Left)
R (Right)	R
Video connection cable
V (Video)	V

DVD Player

AUDIO OUTPUT

VIDEO OUTPUT

DIGITAL OPTICAL OUTPUT

DIGITAL COAXIAL OUTPUT

Digital audio connections

This receiver has a powerful digital signal processor for use with DVD players, DAT decks, MD player, and CD players. The digi- tal inputs, COAXIAL 1, 2 and OPTICAL can be assigned to individual input selector but- tons, so when an input selector button is pressed, the assigned digital input is used instead of the corresponding analog input. (See page 19.)

COAXIAL COAXIAL

ANTENNASUB21 WOOFER

PRE OUT

		R	L
		(REC)
	AM	OUT		R	L
		TAPE	MONI-	FRONT
		(PLAY)	TOR
			OUT
		IN
				SURROUND
	FM	DVD	IN
	75
		VIDEO 1	IN
	GND			CENTER	SUB
			OUT		WOOFER
L		VIDEO 2
			IN	MULTI CH INPUT
R		R	L	V
PHONO	CD

OPTICAL CENTER R L

DIGITAL INPUT

RL

	REMOTE CONTROL
A	R	L	AC OUTLETS
	CENTER	SURROUND	AC 230V 50Hz
	SPEAKER	SPEAKERS	SWITCHED
			TOTAL 100W MAX.

TX-DS484

B

RL

FRONT SPEAKERS

AUDIO IN		VIDEO IN
AUDIO OUT		VIDEO OUT
	Video Cassette Recorder

Notes:

VIDEO IN

: signal flow

Monitor TV

•When using a playback-only VCR, you need to make only the output connections.

•This receiver can be used with only a monitor TV equipped with a video input jack.

•Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).

•A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT and VIDEO 2 will not work.

•Remove the protective cap attached to the DIGITAL INPUT OPTICAL jack before making the connection. When this jack is not used, replace the protective cap.

7