Planar C3215 user manual Appendix a Product Specifications

Page 42

REFERENCE GUIDE

Appendix A: Product Specifications

General Specifications

The Clean Screen II is an IBM compatible PC integrated with a color LCD screen. It supports an Intel Socket 9 Pentium 266 MHz microprocessor and memory configurations to 256 MB FPM, EDO DRAM, to 256 MB 66 MHz SyncDRAM. The system supports all EIDE and Ultra DMA/33 hard drives in the 3.5-inch form factor. The system includes a 15-inch AMLCD-TFT display supporting resolutions of 640 x 480, 800 x 600, and 1024 x 768. The entire unit is rated to withstand shocks of up to 50 g, is powered by a single power supply, and is certified to meet the UL2601.1 standard for safety. The system provides two Universal Serial Bus ports, two ser- ial ports, one AT keyboard port, one external floppy drive port, and one PC Card Type III expan- sion socket. Additionally, the system provides onboard Ethernet connectivity with either 10 or 100Base-T support. The unit can be safely wiped down without interrupting operation.

In short, the Clean Screen II PC provides compact, rugged, and efficient PC support to medical, industrial, and clean room applications.

LCD Support

The standard Clean Screen II display is a 15-inch, 1024 x 768, 36-bit TFT-AM LCD panel.

VGA/Flat Panel Graphics Controller

A Chips and Technologies video-accelerated 69000 controller with 2 MB embedded SDRAM memory and 64-bit GUI is used to implement a high performance flat panel video interface.

Cardbus Interface

A Texas Instruments PCI1250A PCI-to-Cardbus Host Adapter chip supplies a Cardbus and PC Card interfaces. The PCI120A is PCI 2.1, PC Card standard, and ACPI 1.0 compliant. The PCI1250A Cardbus controller is also connected to IRQ3, IRQ4, IRQ5, IRQ7, IRQ11, IRQ12, IRQ14, and IRQ15 for ISA legacy support.

Ethernet Support

An Intel 82558 Ethernet controller is used to implement a high performance PCI-based 10/100Base-T Ethernet interface. The controller is a highly integrated Ethernet solution which provides a complete Ethernet node in a single IC. The controller is a bus master device which allows high data throughput with low CPU and system bus utilization.

Appendix A: Product Specifications 31

Image 42 Contents
User’s Manual USER’S Manual Integrated Computer with LCD Color DisplayIi Planar Clean Screen II PC User’s Manual Commencement of Warranty Federal Communications Commission FCC RequirementsCanadian Emissions Requirements Limitation of Warranty Duration of WarrantyPlace of Repair or Replacement InstallationTable of Contents Vi Planar Clean Screen II Screen PC User’s Manual Vii Reference GuideWhat’s in this manual? Before You BeginWhat’s in the box? What if I’m missing something?Safety Instructions Clean Screen II Mounts and AccessoriesFront Panel Connections BottomChapter One The Installation Express Chapter Four System SetupChapter Two The Clean Screen II PC Clean Screen II FactsWelcome Chapter Two The Clean Screen II PC Back Housing InsideChapter Two The Clean Screen II PC Chapter Three Hardware Installation and Replacement Removing the Back HousingInstalling Memory To install a memory moduleTo remove a memory module Memory Map Range CPU address Region CachedInstalling the new hard disk Replacing the Hard Disk DriveRemoving the existing hard disk Replacing the Battery Flash memory. See Chapter Five Bios SetupReplacing the Fuse Mounting the Clean Screen Connecting Peripherals Chapter Four System SetupConnecting the Keyboard PC Card SlotFloppy Drive Connection Power SupplyPower Cord Selection USB ConnectionSetup F2 Powering Up the Clean Screen II PCPower On Driver OverviewChapter Five Bios Setup Entering the Bios Setup ProgramSetup Screens Main Menu System Memory Boot Options Sub-MenuBoot-Time Diagnostic Screen Extended MemoryType Primary Master/Slave Sub-Menus under Main MenuAutotype Fixed Disk Multi-Sector TransfersUltra DMA Mode LBA Mode ControlTransfer Mode Bit I/OBoot Options Sub-Menu under Main Menu Reset Configuration Data Device Configuration Sub-MenuInstalled OS Win Large Disk Access ModePCI Configuration Sub-Menu PS2 MouseLegacy USB Support Device Configuration Sub-Menu under Advanced Menu Floppy Disk Controller Idle Mode Power Management MenuPower Savings Standby Timeout Resume On Time Resume Time IDE Monitoring Removable Devices Boot MenuHard Drive Removable FormatExit Menu Cleaning Tips Chapter Six Care and CleaningMaintenance Tips Approved cleaning solutions includeAppendix a Product Specifications Floppy Disk Drive Port External Serial PortsUSB Ports Optional Resistive Touch Screen ControllerEnvironmental Specifications Description PinAppendix B Programming Interface Assigned and Available IRQsDMAs Address List Address DeviceAppendix C Troubleshooting Troubleshooting ProcedureAnti-Virus Alert Boot Failures CausesProblems At Initial System Startup Problems After the System Has Been Running CorrectlyProblems Running New Application Software Problems Operating PC CardsProblems with Ethernet Problems and Suggestions What happens What to doSee Problems at Initial System Start-up Error and Information Messages Error Message / Beeps ExplanationError Message Explanation PostPCI Configuration Status and Error Messages Message ExplanationResetting the System Cmos Configuration Appendix D Touch Screen optionalFor Service For Further Information and Driver UpdatesAppendix E Technical Support Planar Clean Screen II PC User’s Manual Canada