Pioneer PRO-141FD, PRO-101FD manual Use the Web Control System, Display Settings

Use Other Equipment With Your Flat Panel Display 06

6.8.2Use the Web Control System

You can access and control the panel from the PC using a web browser. To use this option, follow the directions below.

•For browsing, use the Internet Explorer. Using any other web browser can cause a distorted image or imperfect contents to appear.

•From the Internet Explorer “Tools” menu, click “Internet Options” to open the General tab. Click “Settings…” in the “Temporary Internet Files” section to select “Every time you start Internet Explorer” under “Check for newer versions of stored pages:”.

Display Settings

When switching browser screens, find the needed screen from the list on the left. Do not use browser buttons and menus, such as Previous Page, Next Page, History and Bookmark. Using these buttons and menus to switch the screens causes an imperfect screen to appear. To select a browser, follow the steps below.

1 ) Enter the obtained IP Address in the browser’s address box.

2 ) Enter “admin” on the password entry screen.

3 ) Click Network to begin entering settings.

;0

			Network
			Web control system
Model	: ******	NAME	:
Name	: ******
Location : ******		Location	:
	******	Installation date	:
Top
		DHCP	:	ON	OFF
Detail Settings		IP address	:
Picture		Sub net mask	:
Terminal		Default gateway	:
Functions		TCP Control Port	:
		UDP Control Port	:
Network Settings		TCP Connection limit :		OFF	ON ...	5	minutes
Network
		LED	:	ON	OFF
E-mail		MAC address	: 00:00:00:00:00:00
ISF				Set

4 ) Enter information in the following fields:

•NAME

•Location

•Installation date

•LED (On/Off)

Note: To change entries other than NAME, Location and Installation date, close the browser then re-open it. To change entries for IP Address, Subnet Mask or Default Gateway, close the browser, change the PC network settings then re-open it.

65

En