06Use Other Equipment With Your Flat Panel Display
6.9.2Assign a Baud Rate
This section describes how to enter the
1 ) Access Serial Setting through the Control Setup menu.
2 ) Select Baud Rate from the Serial Setting menu.
3 ) Select the desired rate from the submenu. The factory default setting is 9600bps.
Baud Rate
1200bps
2400bps
4800bps
9600bps
19200bps
38400bps
Note: This setting applies to all input sources.
6.10 Select the Integrator Mode
Integrator Mode provides alternative options when using specific functions/settings and picture adjustment menus.
Notes: Integrator Mode is only available in English.
After entering the Integrator Mode, the following options on the Home Menu are reset to the factory defaults:
•Picture
•Screen
After entering the Integrator Mode, the following options remain unchanged:
•Power Control
•Option
•Input Setup
•Control Setup
To switch to the Integrator Mode, follow the directions below. 1 ) Press INPUT to select the desired input.
2 ) Press DISPLAY to reveal current settings.
Status information on the selected input appears on screen.
INPUT2
Component
- - -
FULL
Standard
70
En