Planar LC12 manual Video Signal Input Requirements, Red video return, Blue video return

4.0Video Signal Input Requirements

4.1Video Input Lines

The Video Signal Connector consists of fifteen (15) positions wired numerically and supplied attached to the Monitor as a chassis mounted connector per definitions listed in Table 2. The "NC" positions of this connector are not used for any purpose.

Pin Number	Signal Name
1	Red Video
2	Green Video
3	Blue Video
4	Monitor Sense Line 3
	(connected to Pin 10)
5	NC
6	Red video return
7	Green video return
8	Blue video return
9	NC
10	Signal Ground Reference
11	Monitor Sense Line 1
	(connected to Pin 10)
12	Monitor Sense Line 2 (NC)
13	Horizontal Sync Input
14	Vertical Sync Input
15	NC

Table 2. Video Signal Connector – Pin Number Assignments

The Video Signal Connector that connects to the customer’s equipment is a female 15-pin connector in a high density 9-pin D-Shell housing. Pin number assignments are defined in Table 2, and physical layout as seen by the interface cable from user logic is shown in Table 4.

Figure 4. Video Signal Connector Illustration

4.2Signal Functions

4.2.1Video Parameters

As seen by the source, input resistance is 75-ohm, ±10%; input capacitance at (150 MHZ) <10-pF.

Coaxial cable is provided for video signal line(s) to match impedances and for EMI attenuation. The video input signal will have a range of 0-mv to 714-mv (maximum)

Title: Product Specification: LC12 High-Bright Monitor	Page 9 of 24
Document Number: 023-0284-01	Revision: A