Onkyo TX-SA706 instruction manual 100, Adjusting the Volume for Zone, Muting Zones

Zone 2—Continued

Adjusting the Volume for Zone 2

Remote

controller

AV receiver/ AV amplifier

On the remote controller, press the [ZONE 2] button, and then use the VOL [q]/[w] button.

On the AV receiver/AV amplifier, use the ZONE 2 LEVEL [q]/[w] buttons.

If your Zone 2 speakers are connected to a receiver or integrated amp in Zone 2, use its volume control to adjust the volume.

Muting Zones

Remote

controller

On the remote controller, press the [ZONE 2] button, and then press the [MUTING] button.

To unmute a zone, on the remote controller, press the [ZONE 2] button, and then press the [MUT- ING] button again.

Notes:

•Only analog input sources are output by the ZONE 2 LINE OUT and ZONE 2 L/R speaker terminals. Dig- ital input sources are not output. If no sound is heard when an input source is selected, check if it’s con- nected to an analog input.

•While Powered Zone 2 is being used, listening modes that need surround back speakers (i.e., Dolby Digital EX, DTS-ES, and THX Select2 Cinema) are unavailable.

•While Zone 2 is on, ufunctions will not work.

•You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that sta- tion will also be used in Zone 2.

•Zones can also be unmuted by adjusting the volume.

100