Onkyo TX-SA706 Listening to the Radio TX-SR706 only, Using the Tuner, Tuning into Radio Stations

Page 57

Listening to the Radio (TX-SR706 only)

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

TUNER

 

 

TUNING MODE

TUNING

/

Listening to the Radio

Use the [TUNER] input selector button to select either AM or FM.

In this example, FM has been selected. Each time you press the [TUNER] but- ton, the input source changes between AM and FM.

Band Frequency

(Actual display depends on country)

Tuning into Radio Stations

Auto Tuning Mode

1

Press the [TUNING MODE] but-

 

 

ton so that the AUTO indicator

 

appears on the display.

2

Press the TUNING Up or Down

 

 

[q]/[w] buttons.

 

Searching stops when a station is

 

found.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.

TUNED

AUTO

FM STEREO

Manual Tuning Mode

1Press the [TUNING MODE] but- ton so that the AUTO indicator

disappears from the display.

2

Press and hold the TUNING Up or

 

 

Down [q]/[w] buttons.

 

The frequency stops changing when

 

you release the button.

 

Press the buttons repeatedly to change

 

the frequency one step at a time.

The North American models change FM frequency in

0.2MHz steps, 10 kHz steps for AM. For other models it’s 0.05 MHz steps for FM and 9 kHz steps for AM. In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.

Tuning into Stations by Frequency

You can tune into AM and FM stations directly by enter- ing the appropriate frequency.

1

Press the [TUNER] button repeat-

 

Remote

edly to select AM or FM, followed

by the [D.TUN] button.

controller

(Actual display depends on country.)

2

Within 8 seconds, use the num-

 

 

ber buttons to enter the fre-

 

quency of the radio station.

 

For example, to tune to 87.5 (FM),

 

press 8, 7, 5.

 

 

57

Image 57
Contents TX-SR706 Avis Important Safety InstructionsPower PrecautionsPreventing Hearing Loss Caution Batteries and Heat Exposure WarningFor British models PrecautionsMake sure you have the following accessories Supplied AccessoriesAmplifier FeaturesProcessing ConnectionsContents Front Panel Front & Rear PanelsTX-SR706 North American model TX-SR706 other than North American model TX-SA706Front & Rear Panels Display TX-SR706 other than North American model Rear PanelPhono Remote ControlComponent Video in 1 Hdmi in 1-4 and OUTDVD V, S, Front L/R VCR/DVR IN/OUTZone 2 Line OUT L/R Front L/R, CENTER, Surr L/R, and Surr Back L/R speakersRemote Controller Installing the BatteriesAiming the Remote Controller Controlling the AV Receiver/AV Amplifier Remote ControllerEnjoying Home Theater About Home TheaterConnecting Your Speakers Connecting the AV Receiver/AV AmplifierSpeaker Connection Precautions Connecting the AV Receiver/AV AmplifierConnecting the Speaker Cables Strip about 5/8 15 mmBi-amping the Front Speakers Bi-amping Speaker HookupTweeter high terminal Connecting the AM Loop Antenna Connecting Antenna TX-SR706 onlyConnecting the Indoor FM Antenna Attach the FM antenna, as shown North American modelsConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaUsing a TV/FM Antenna Splitter AV Connection Color Coding About AV ConnectionsOptical Digital Jacks AV Cables & JacksConnecting Both Audio & Video Which Connections Should I Use?Video Connection Formats Audio Connection Formats Signal SelectionVideo Connection Connecting a TV or ProjectorAudio Connection HintConnecting a DVD Player Hooking Up the Multichannel DVD Input Connecting a VCR or DVD Recorder for Playback Make the audio connection a Connecting a VCR or DVD Recorder for RecordingSatellite, cable, set-top box, etc Connecting a Game Console Camcorder, etc Connecting a Camcorder or Other DeviceAbout Hdmi Connecting Components with HdmiSupported Audio Formats About Copyright ProtectionAudio Signals Video SignalsMaking Hdmi Connections StepConnecting a CD Player or Turntable CD Player or Turntable MM with Built-in Phono Preamp StepTurntable MM with no Phono Preamp Built-in Connecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting a Tuner TX-SA706 only Connecting a Power AmplifierIf Your iPod Supports Video Connecting an RI DockConnecting the Power Cord Connecting Onkyo u ComponentsAuto Power On/Standby Direct ChangeTurning On the AV Receiver/AV Amplifier Turning On and StandbySmooth Operation in a Few Easy Steps Using the Onscreen Setup Menus First Time SetupUsing the Display to change the settings Onscreen Setup Menus and DisplayVideo Input Setup First Time SetupHdmi Input Setup Press the Setup buttonComponent Video Setup Tons to select 1. Input Assign Digital Input SetupThen press Enter Tons to select 3. Digital AudioPress the Receiver button, followed by the Setup button Speaker SettingsSpeaker Setup menu appears Speaker Settings menu appearsTons to select 2. OSD Setup TV Format Setup Not North American modelsWhen you’ve finished, press Tons to select 6. MiscellaAM Frequency Step Setup on some models Press the Tape or GAME/TV Changing the Input DisplayInput selector button so that Tape or GAME/TV appearsUsing Audyssey MultEQ Automatic Speaker Setup Audyssey MultEQMeasurement Positions 1st measurement positionTurn on the AV receiver/AV amplifier and the connected TV Automatic speaker setup startsPress Enter Following screen appearsMicrophone Disconnect the speaker setupSpeaker Detect Error Error MessagesWriting Error Ambient noise is too highUsing a Powered Subwoofer Changing the Speaker Settings ManuallySee Using the Listening Modes on Select a listening mode and enjoyBasic Operations Selecting the Input SourceAdjusting the Bass & Treble Using the Multichannel DVD InputSetting the Display Brightness Basic OperationsUsing Headphones Using the Sleep TimerMuting the AV receiver/AV amplifier TipTuning into Radio Stations Using the TunerListening to the Radio TX-SR706 only Listening to the RadioSelecting Presets Presetting AM/FM StationsDeleting Presets Listening to the Radio TX-SR706onlyRDS Program Types PTY Using RDS not North American modelDisplaying Radio Text RT Finding Stations by Type PTYListening to Traffic News TP Recording AV RecordingRecording Separate AV Sources Selecting with the Remote Controller Using the Listening ModesSelecting Listening Modes Selecting on the AV receiver/AV amplifierUsing the Listening Modes Listening Modes Available for Each Source FormatAnalog and PCM Sources Dolby Digital, and Dolby Digital Plus Sources DTS-ES DTS SourcesTrueHD Sources DTS-HD Sources DSD DTS Express and DSD SourcesAbout the Listening Modes Dolby TrueHD DTS-HD High Resolution AudioChannel source + Dolby PLIIx Music Channel source + Dolby PLIIx MovieOnkyo Original DSP Modes Onscreen Setup Menus Advanced SetupSpeaker Setup Advanced SetupSpeaker Settings See Speaker Settings onIf no center speaker is connected, select Double Bass Low-Pass Filter for the LFE ChannelTons to select Double Bass Off THXRepeat for all speakers Speaker DistanceSpeaker Level Calibration Repeat until the volumeTest tone from each speaker Is the sameUse the Left and Right e/r buttons to select Equalizer SettingOff AudysseyTHX Audio Setup THX Audio Setup screen appearsRepeat and 7 for each speaker 1ft 0.3m 4ft 1.2m defaultFt 4 ft 0.3 m 1.2 m Tons to select Loudness PlusAudio Adjust Functions Multiplex/Mono SettingsPLIIx/Neo6 Music Mode Settings Theater-Dimensional Listening Setting Dolby EX Input Signal SettingDSD Setting LFE Level SettingsTone Control Settings Adjust Using the Audio ButtonLate Night Function Re-EQ FunctionMusic Optimizer Audyssey Dynamic EqtmSpeaker Levels SyncSources Assigning Listening Modes to InputIntelliVolume Source SetupSelects when you want to cancel the name entry Name EditTo correct a character Picture Adjust Volume Setup Miscellaneous Volume/OSD SetupOSD Setup Remote Control Hardware SetupZone Tuner TX-SR706 onlyZoom Mode Output ResolutionAnalog Multich Sirius Parental Lock On North American modelAudio TV Out Film ModeLip Sync ColorPower Control ControlTV Control Lock Setup LockedUnlocked Digital Input Signal Formats Automatic Audio Input Selection SetupConnecting Your Zone 2 Speakers to an Amp in Zone Connecting ZoneZone Zone 2 12V TriggerTons to select 2. Zone2, Setting the Powered ZoneZone2 menu appears Not ActUsing Zone Controlling Zone 2 with the Remote ControllerControlling Zone 2 from the AV receiver/AV amplifier Adjusting the Volume for Zone 100Muting Zones Using a Multiroom Kit with Zone Using a Multiroom Kit with a Cabinet101 Entering Remote Control Codes Preprogrammed Remote Control CodesControlling Other Components 102Resetting Remote Mode Buttons Remote Control Codes for Onkyo Components Connected via uResetting the Remote Controller 103Controlling a TV 104Controlling a DVD Player, or DVD Recorder 105Controlling a VCR or PVR 106Controlling a Satellite Receiver or Cable Receiver 107108 Controlling a CD Player, CD Recorder, or MD PlayerDisc +/- button Controlling an RI Dock 109110 Controlling a Cassette RecorderControlling a Tuner TX-SA706 only 111 Learning Commands112 Using MacrosMaking Macros Running Macros113 Specifications114 Troubleshooting115 Troubleshooting116 117 Important Note Regarding Video Playback 118119 Video Resolution Chart3 4 4 7 2

TX-SA706 specifications

The Onkyo TX-SA706 is a sophisticated, high-performance AV receiver designed to elevate your home theater experience. As part of Onkyo's esteemed lineup, this receiver offers a combination of advanced features, innovative technologies, and impressive specifications that cater to the needs of audiophiles and home cinema enthusiasts alike.

One of the standout features of the TX-SA706 is its powerful amplification system. With multiple channels delivering robust power output, it is capable of driving most speaker configurations, from a standard 5.1 surround sound setup to more elaborate systems. This ensures that you get a rich and immersive audio experience perfect for movies, music, and gaming.

The TX-SA706 supports high-definition audio formats, including Dolby Atmos and DTS:X, allowing for an intricate and lifelike soundstage. These immersive technologies use object-based audio to place sound in a three-dimensional space, creating a more engaging listening experience. Coupled with the receiver’s ability to decode lossless audio formats, listeners can enjoy their content in superior quality.

Video performance is equally impressive, with support for 4K Ultra HD video pass-through and upscaling. The receiver features multiple HDMI inputs and outputs, allowing for seamless connectivity with all your devices, including Blu-ray players, gaming consoles, and streaming gadgets. Additionally, it is compatible with HDR10, Dolby Vision, and BT.2020, ensuring vibrant colors and sharp images for a cinematic viewing experience.

Connectivity options are extensive, as the TX-SA706 comes equipped with built-in Wi-Fi and Bluetooth capabilities. This allows for easy streaming from various devices and music services, making it convenient to access your favorite playlists and tracks wirelessly. For those who prefer a more traditional approach, the receiver is outfitted with multiple analog and digital inputs, ensuring compatibility with a wide array of audio sources.

The TX-SA706 also includes Zone 2 and Zone 3 features, enabling multi-room audio setups so that different areas of your home can enjoy different audio sources simultaneously. This flexibility makes it a perfect choice for those who wish to extend their audio experience beyond a single room.

In summary, the Onkyo TX-SA706 is a versatile AV receiver that exhibits powerful performance, advanced audio and video technologies, and comprehensive connectivity options. Its combination of immersive sound, stunning visuals, and multi-room capabilities make it an excellent choice for enhancing your home entertainment system, ensuring that every viewing and listening session is one to remember.