Onkyo TX-SA706 instruction manual Advanced Setup, Speaker Setup, See Speaker Settings on

Advanced Setup—Continued

Speaker Setup

Some of the settings in this section are set automatically by the Automatic Speaker Setup function (see page 49). Here you can check the settings made by the Automatic Speaker Setup function, or set them manually, which is useful if you change one of the connected speakers after using the Automatic Speaker Setup function.

Note:

The Speaker Setup cannot be carried out while head- phones are connected to the AV receiver/AV amplifier.

Speaker Settings

See “Speaker Settings” on page 45.

Speaker Configuration

These settings are set automatically by the Automatic Speaker Setup function (see page 49).

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. The following crossover frequencies can be specified:

“Full Band”, “40Hz”, “50Hz”, “60Hz”, “70Hz”, “80Hz (THX)”, “90Hz”, “100Hz”, “120Hz”, “150Hz”, or “200Hz”.

Specify “Full Band” for speakers that can output low- frequency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover fre- quency will be output by the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequencies.

Please note that THX recommends any THX main speakers be set to “80Hz(THX)”. If you set up your speakers using the Automatic Speaker Setup function, please make sure manually that any THX speakers are set to 80 Hz (THX) crossover.

1

2-11 2, 3

1, 12

1

2

3

4

Press the [RECEIVER] button fol- lowed by the [SETUP] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [ENTER].

The “Speaker Setup” menu appears.

2.Speaker Setup

1. Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

Use the Up and Down [q]/[w] but- tons to select “2. Speaker Con- figuration”, and then press [ENTER].

The “Speaker Configuration” menu appears.

2–2. Speaker Configuration

Subwoofer	Yes
Front	80Hz (THX)
Center	80Hz (THX)
Surround	80Hz (THX)
Surr Back	80Hz (THX)
Surr Back Ch	2ch
LPF of LFE	80Hz (THX)
Double Bass	Off (THX)

Use the Up and Down [q]/[w] but- tons to select “Subwoofer”, and then use the Left and Right [e]/ [r] buttons to select:

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

73