Operation
Powering On/Off the Projector
Powering On the Projector:
1.Complete the AC power cord and peripheral signal cable(s) connections.
2.Press 
to turn on the projector.
The projector takes a minute or so to warm up.
3.Turn on your source (computer, notebook, DVD, etc.). The projector automatically detects your source.
If you are connecting multiple sources to the projector simultaneously, press SOURCE on the projector or Source on the
remote control to select your desired signal or press your desired signal key on the remote control.
Warning
Never look into the lens when the lamp is on. This can damage your eyes.
This focal point concentrates high temperature. Do not place any object near it to avoid possible fire hazard.
Powering Off the Projector:
1.Press 
to turn off the projector lamp. You will see a message "Power off? Press Power again" appear on the screen.
2.Press 
again to confirm.
The cooling fans continue to operate for cooling cycle.
When the Power LED becomes steady blue, the projector has entered
If you want to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered
mode. Once in 
to restart the projector.
3.Disconnect the AC power cord from the electrical outlet and the projector.
4.Do not turn on the projector right after power off.
Warning
When Quick Resume is on, if turning off the projector accidentally and Quick Resume selected within a period of 100 seconds, the projector will instantly power on again.
When Quick Resume is off, if turning off the projector, users need to wait until the cooling process is finished and then restart the projector. It will take a few minutes because the fan will keep running until the internal temperature is reduced to certain level.