Garmin 906-2000-00 owner manual System Layout

Page 8

System Layout

Handheld/Remote

Sensor Ball: Mount in front 1/2 of boat.

Throttle

Actuator

Mounts on carburetor on motor.

GPS connection

NMEA 0183

Battery 12V

Tach sensor

wire:Attaches to spark plug wire on kicker.

Electrohydraulic Unit: Mount near transom.

Deckmount On/Off switch: Mounts near kicker motor, near transom.

Cylinder

Cylinder Mounting Bracket: Mounts on Motor lower end.

8

Image 8

Contents TR-1 Gold Table of Contents Thank YouSafety TR-1 Gold Autopilot System Parts List Page TR-1 Gold Specifications Fluid BioSOY OilIntroduction PreparationMoving Parts System Layout Installation of The Electro-Hydraulic Unit ToolsMounting Hydraulic Unit Installation of the Sensor Ball Page Installation of the Deckmount and Tach Installation of the Handheld/Remote Before you start……… Fig aStep Four Reconnect the cylinder rod end Step Nine Hose Clamp GPS ConnectionsStep Eight Check hose fit Introduction to Operation and Adjustments GPS steering. Some GPS units may not support these features Operating The SystemChange Heading with Remote Steer Power On/Off Deckmount SwitchEngaging Heading Hold Engaging Autopilot Page Set North GPS SteeringCourse Overground Hold Three Leaf Clover Pattern GPS Steering Steer To Waypoints GPS SteeringOrbit Waypoint GPS Steering Search Pattern GPS Steering Circles Changing Heading With MOBThrottleThrottleUp/Down Selecting Special Functions How to Make System Changes with Setup Automated Setup Codes Special Function Setup CodesTachometer Codes Throttle CodesFine Tuning Codes Code 1 Sea State FilterCodes 15 CodeCode Compass Calibration and Tuning your Autopilot This will lock in your new settings Modified setup parameters into start up defaultsRudder and Counter Rudder Gain Well Tuned Response Rudder Gain Effects Limited Warranty