Tools
You should gather the following tools before beginning installation. See throttle and cylinder supplements for any additional tools that may be needed for your application.
Tools
Power Drill
#1 Phillips screw driver
.125 (1/8) or 3.17 mm dia. drill
.469 (15/32) or 11.90 mm dia. drill Roll of masking tape
Rags
Knife
Pliers Silicone RTV
Loctite or similar product Electrical grease compound (Dow Corning #4)
Fig .4
Installation of The Electro-Hydraulic Unit
Please read the complete instructions thoroughly before starting your installation. If you have any questions call our Tech Support line.
Locate the
Step one (Template)
Find the mounting template in your autopilot documentation package. Use the wall or floor section of the template as needed. Decide which screw type you need. Hold the template in the place with tape and drill right through it in the three indicated locations. See fig.5. Remove template and install screws in the indicated locations on template. Tighten these 2 screws down to 3/32” from the surface to allow enough space for the bracket on the pump to slide behind the screw.
Fig. 5 | 9 |
|