Garmin 906-2000-00 owner manual Safety

Page 3

Safety

You are responsible for the safe and prudent operation of your vessel. Your TR-1 Gold Autopilot is a tool that will enhance your capability to operate your boat and catch fish. It does not relieve you from the responsibility for safe operation of your vessel. You must avoid hazards to navigation and never leave the helm unattended.

You must always be prepared to promptly regain manual control of your kicker. The autopilot and the throttle actuators can fail hard over. Learn to operate your autopilot on calm and hazard free open water.

In case the autopilot becomes inoperable, remove the in line fuse from the battery power cable.

The steering cylinder can be removed from its mounting bracket on the outboard in case of hydraulic jamming.

Removing the actuating link between the stepper motor and the carburetor butterfly crank can disable the electric throttle.

Caution:

Before drilling holes in your boat, be sure you know what you are drilling into. Watch out for fuel tanks, electrical cables, and hydraulic hoses.

Do not run your pilot with the outboard hard on the steering stops for any extended time or you will burn out the pump motor.

Be sure to leave the system in Standby mode when Autopilot is not in use, or if the kicker motor is not running.

We recommend you use only BioSOY hydraulic fluid in your autopilot hydraulics.

Keep your hands out of the outboard steering hinge area, the autopilot may steer the motor and smash (or worse) your fingers.

3

Image 3
Contents TR-1 Gold Thank You Table of ContentsSafety TR-1 Gold Autopilot System Parts List Page Preparation TR-1 Gold SpecificationsFluid BioSOY Oil IntroductionMoving Parts System Layout Tools Installation of The Electro-Hydraulic UnitMounting Hydraulic Unit Installation of the Sensor Ball Page Installation of the Deckmount and Tach Installation of the Handheld/Remote Fig a Before you start………Step Four Reconnect the cylinder rod end GPS Connections Step Eight Check hose fitStep Nine Hose Clamp Introduction to Operation and Adjustments Operating The System GPS steering. Some GPS units may not support these featuresPower On/Off Deckmount Switch Engaging Heading Hold Engaging AutopilotChange Heading with Remote Steer Page GPS Steering Course Overground HoldSet North Steer To Waypoints GPS Steering Orbit Waypoint GPS SteeringThree Leaf Clover Pattern GPS Steering Search Pattern GPS Steering Changing Heading With MOB CirclesThrottleThrottleUp/Down Selecting Special Functions How to Make System Changes with Setup Throttle Codes Automated Setup CodesSpecial Function Setup Codes Tachometer CodesCode Fine Tuning CodesCode 1 Sea State Filter Codes 15Code Compass Calibration and Tuning your Autopilot Modified setup parameters into start up defaults This will lock in your new settingsRudder and Counter Rudder Gain Well Tuned Response Rudder Gain Effects Limited Warranty