InFocus P1501 Image not square, Adjust Keystone on keypad, Square image, Image not sharp, Problem

Page 18

Problem	Solution	Result

Image not square	Adjust Keystone on keypad	Square image

Image not sharp

Adjust Sharpness in the Basic Picture menu

Correct image

Image does not fit 4:3 or 16:9 screen

Change aspect ratio to 4:3 or 16:9 in Basic Picture>Aspect ratio menu

Correct image

Image 18

Contents IN1501, IN1503 Regulatory models P1501, P1503009-1313-02 DISPERINDAG No. 0287/1.824.51/09.03 FCC Warning Declaration of ConformityTrademarks CanadaTable of Contents Important Operating Considerations for Safety Introduction Product specificationsAccessories Online registrationConnector panel IN1503 Positioning the projectorIN1501 Table 1 IN150166/1.7 90/2.355/1.4 150/3.8DisplayLink Connecting a computer sourceConnecting power VGA connectionDisplaying an image ? No start up screen? Get help on pageAdjusting the image What is Aspect Ratio? 43 screen169 screen 43 mode 169 mode Native mode NTSC only HDMI 1.3 connection Connecting a video deviceComposite video connection VGA connectionShutting down the projector Troubleshooting your setupTable 3 Status indicator light behavior and meaning Screen Save TimePlug power cord into the projector Problem No start up screenSolution press power buttonResult Computer image projected Problem No computer image, just the words “Signal out of range”Only my laptop’s background appears, not the Desktop icons Background and Desktop projectedresolution of the projector Start Settings Control ProblemSet your computer’s display resolution to the native Panel Display Settings tabImage not square Adjust Keystone on keypadAdjust Sharpness in the Basic Picture menu Square imageAdjust color, tint, brightness, contrast in the Basic Turn off Ceiling Mount in Setup menuTurn off Rear Project in Setup menu Image upside downStartup Screen The video embedded in my PowerPointfor video troubleshooting information presentation does not play on the screenwon’t turn on, Lamp light is turned on “Replace lamp” message appears at startup, lampLamp must be replaced see page lamp doorUsing the remote control Troubleshooting the remoteUsing the audio Using the projector’s speakersTroubleshooting Audio Using the keypad buttons Presentation features Optimizing computer imagesOptimizing video images Customizing the projectorUsing the menus Basic Picture menu Advanced Picture menu Setup menu To enter the PIN at projector startup To change the PINProjector Info a read-only display of current projector settings Status and Service menuSource Info a read-only display of current source settings Factory Reset restores all settings to their defaultImage File Types Using LitePort IN1503 onlyUsing the LitePort Menu Viewing a Slide ShowDisplaying PowerPoint Slides Troubleshooting LitePort Cleaning the lens MaintenanceUsing the security lock WARNINGSReplacing the projection lamp Page INDEX NumericsI Image