InFocus IN1503, P1501 manual Troubleshooting LitePort

Page 35

Troubleshooting LitePort

•If images load slowly: Make sure you are using a newer USB 2.0- compatible (high speed) USB flash drive. Larger image file sizes may also slow down the player; to reduce file size, use an image editing program on your computer to resize images smaller; for the best balance between image quality and speed, resize images to be 1024 pixels wide.

•If no images are found, or some images are not shown, or you only see folder thumbnails but no images: Make sure that images are JPEG file type (file extensions .JPEG and .JPG); other file types are not supported and will be ignored.

•If you see a blank screen, or a logo, or the wrong input source (computer, video, etc.) instead of your images: Keep pressing the Source button on the keypad or remote until the LitePort message is displayed (if you still don't see any images, make sure the USB flash drive is correctly and completely plugged into the projector's LitePort connector).

•If nothing happens when you connect your USB flash drive, and you cannot select the LitePort input source as described above: Check the format of your USB storage device. LitePort only supports USB storage devices formatted as FAT32. Devices formatted as NTFS, and non-storage devices (such as cameras) are not supported.

•If images saved by PowerPoint are low quality: Make sure to do step 3 when following the steps in the Displaying PowerPoint Slides section above.

34

Image 35

Contents 009-1313-02 DISPERINDAG No. 0287/1.824.51/09.03 IN1501, IN1503Regulatory models P1501, P1503 Canada Declaration of ConformityTrademarks FCC WarningTable of Contents Important Operating Considerations for Safety Online registration Product specificationsAccessories IntroductionConnector panel Table 1 IN1501 Positioning the projectorIN1501 IN1503150/3.8 90/2.355/1.4 66/1.7VGA connection Connecting a computer sourceConnecting power DisplayLink? No start up screen? Get help on page Displaying an imageAdjusting the image 169 screen 43 mode 169 mode Native mode NTSC only What is Aspect Ratio?43 screen VGA connection Connecting a video deviceComposite video connection HDMI 1.3 connectionScreen Save Time Troubleshooting your setupTable 3 Status indicator light behavior and meaning Shutting down the projectorpress power button Problem No start up screenSolution Plug power cord into the projectorBackground and Desktop projected Problem No computer image, just the words “Signal out of range”Only my laptop’s background appears, not the Desktop icons Result Computer image projectedPanel Display Settings tab ProblemSet your computer’s display resolution to the native resolution of the projector Start Settings ControlSquare image Adjust Keystone on keypadAdjust Sharpness in the Basic Picture menu Image not squareImage upside down Turn off Ceiling Mount in Setup menuTurn off Rear Project in Setup menu Adjust color, tint, brightness, contrast in the Basicpresentation does not play on the screen The video embedded in my PowerPointfor video troubleshooting information Startup Screenlamp door “Replace lamp” message appears at startup, lampLamp must be replaced see page won’t turn on, Lamp light is turned onTroubleshooting the remote Using the remote controlTroubleshooting Audio Using the audioUsing the projector’s speakers Using the keypad buttons Optimizing computer images Presentation featuresCustomizing the projector Optimizing video imagesUsing the menus Basic Picture menu Advanced Picture menu Setup menu To change the PIN To enter the PIN at projector startupFactory Reset restores all settings to their default Status and Service menuSource Info a read-only display of current source settings Projector Info a read-only display of current projector settingsViewing a Slide Show Using LitePort IN1503 onlyUsing the LitePort Menu Image File TypesDisplaying PowerPoint Slides Troubleshooting LitePort WARNINGS MaintenanceUsing the security lock Cleaning the lensReplacing the projection lamp Page I Image INDEXNumerics