InFocus P1501, IN1503 manual Optimizing video images, Customizing the projector

Page 26

Optimizing video images

After your video device is connected properly and the image is on the screen, you can optimize the image using the onscreen menus. For general information on using the menus, see page 26.

•Adjust the Keystone, Contrast, Brightness, Color, or Tint in the Basic Picture menu (page 27).

•Change the Aspect Ratio. Choose the option that best fits your input source (page 27).

•Select a Sharpness setting (page 27).

•Adjust the Color Temperature. Select a listed warmth value (page 28).

•Turn on Overscan to remove noise on the edges of the image (page 28).

Customizing the projector

You can customize the projector for your specific setup and needs. See page 29 to page 30 for details on these features.

•For rear projection, turn Rear Project on in the Setup menu.

•For ceiling mounted projection, turn Ceiling Mount on in the Setup menu.

•Specify which source the projector checks first for active video during power- up.

•Specify the function of the Custom key on the remote.

•Turn the projector’s display messages on and off.

•Turn on power saving features.

•Specify appearance of blank screen and startup screen.

•Specify the language viewed on the menus.

•Save settings for the active source as a preset.

25

Image 26

Contents 009-1313-02 DISPERINDAG No. 0287/1.824.51/09.03 IN1501, IN1503Regulatory models P1501, P1503 FCC Warning Declaration of ConformityTrademarks CanadaTable of Contents Important Operating Considerations for Safety Introduction Product specificationsAccessories Online registrationConnector panel IN1503 Positioning the projectorIN1501 Table 1 IN150166/1.7 90/2.355/1.4 150/3.8DisplayLink Connecting a computer sourceConnecting power VGA connectionDisplaying an image ? No start up screen? Get help on pageAdjusting the image 169 screen 43 mode 169 mode Native mode NTSC only What is Aspect Ratio?43 screen HDMI 1.3 connection Connecting a video deviceComposite video connection VGA connectionShutting down the projector Troubleshooting your setupTable 3 Status indicator light behavior and meaning Screen Save TimePlug power cord into the projector Problem No start up screenSolution press power buttonResult Computer image projected Problem No computer image, just the words “Signal out of range”Only my laptop’s background appears, not the Desktop icons Background and Desktop projectedresolution of the projector Start Settings Control ProblemSet your computer’s display resolution to the native Panel Display Settings tabImage not square Adjust Keystone on keypadAdjust Sharpness in the Basic Picture menu Square imageAdjust color, tint, brightness, contrast in the Basic Turn off Ceiling Mount in Setup menuTurn off Rear Project in Setup menu Image upside downStartup Screen The video embedded in my PowerPointfor video troubleshooting information presentation does not play on the screenwon’t turn on, Lamp light is turned on “Replace lamp” message appears at startup, lampLamp must be replaced see page lamp doorUsing the remote control Troubleshooting the remoteTroubleshooting Audio Using the audioUsing the projector’s speakers Using the keypad buttons Presentation features Optimizing computer imagesOptimizing video images Customizing the projectorUsing the menus Basic Picture menu Advanced Picture menu Setup menu To enter the PIN at projector startup To change the PINProjector Info a read-only display of current projector settings Status and Service menuSource Info a read-only display of current source settings Factory Reset restores all settings to their defaultImage File Types Using LitePort IN1503 onlyUsing the LitePort Menu Viewing a Slide ShowDisplaying PowerPoint Slides Troubleshooting LitePort Cleaning the lens MaintenanceUsing the security lock WARNINGSReplacing the projection lamp Page I Image INDEXNumerics