InFocus P1501, IN1503 manual

Page 38

1Turn off the projector and unplug the power cord.

2Wait 60 minutes to allow the projector to cool thoroughly.

3Remove the lamp door by (a) removing the screw on the side of the lamp door,

(b) lifting the door off.

4Loosen the captive screw that attaches the lamp housing to the projector. Carefully remove the lamp housing. Dispose of the lamp in an environmentally proper manner.

5Install the new lamp housing and tighten the screw.

6Re-attach the lamp connector to the projector.

7Replace the lamp door by sliding it into place.

8Plug in the power cord and press the Power button to turn the projector back on.

9To reset the lamp hour timer, navigate to the Status and Service menu and select Reset Lamp Hours. See page 31 for details.

turn off and unplug	wait 60 minutes
projector

(a)

(b)

loosen screw

Image 38

Contents 009-1313-02 DISPERINDAG No. 0287/1.824.51/09.03 IN1501, IN1503Regulatory models P1501, P1503 FCC Warning Declaration of ConformityTrademarks CanadaTable of Contents Important Operating Considerations for Safety Introduction Product specificationsAccessories Online registrationConnector panel IN1503 Positioning the projectorIN1501 Table 1 IN150166/1.7 90/2.355/1.4 150/3.8DisplayLink Connecting a computer sourceConnecting power VGA connectionDisplaying an image ? No start up screen? Get help on pageAdjusting the image 169 screen 43 mode 169 mode Native mode NTSC only What is Aspect Ratio?43 screen HDMI 1.3 connection Connecting a video deviceComposite video connection VGA connectionShutting down the projector Troubleshooting your setupTable 3 Status indicator light behavior and meaning Screen Save TimePlug power cord into the projector Problem No start up screenSolution press power buttonResult Computer image projected Problem No computer image, just the words “Signal out of range”Only my laptop’s background appears, not the Desktop icons Background and Desktop projectedresolution of the projector Start Settings Control ProblemSet your computer’s display resolution to the native Panel Display Settings tabImage not square Adjust Keystone on keypadAdjust Sharpness in the Basic Picture menu Square imageAdjust color, tint, brightness, contrast in the Basic Turn off Ceiling Mount in Setup menuTurn off Rear Project in Setup menu Image upside downStartup Screen The video embedded in my PowerPointfor video troubleshooting information presentation does not play on the screenwon’t turn on, Lamp light is turned on “Replace lamp” message appears at startup, lampLamp must be replaced see page lamp doorUsing the remote control Troubleshooting the remoteTroubleshooting Audio Using the audioUsing the projector’s speakers Using the keypad buttons Presentation features Optimizing computer imagesOptimizing video images Customizing the projectorUsing the menus Basic Picture menu Advanced Picture menu Setup menu To enter the PIN at projector startup To change the PINProjector Info a read-only display of current projector settings Status and Service menuSource Info a read-only display of current source settings Factory Reset restores all settings to their defaultImage File Types Using LitePort IN1503 onlyUsing the LitePort Menu Viewing a Slide ShowDisplaying PowerPoint Slides Troubleshooting LitePort Cleaning the lens MaintenanceUsing the security lock WARNINGSReplacing the projection lamp Page I Image INDEXNumerics