Marantz PD6150D manual Wide Screen Operation with Computer Signals, Normal size screen 43 or Sxga

Page 18

Wide Screen Operation with Computer Signals

Switch to the wide screen mode to expand the 4 : 3 image to fill the entire screen.

1.Press the WIDE button on the remote control.

2.Within 3 seconds ...

Press the WIDE button again.

The screen size switches as follows:

→ NORMAL → ANAMORPHIC → ZOOM

NORMAL size screen (4:3 or SXGA 5:4)

The picture has the same size as the normal computer image.

ANAMORPHIC size screen

The image is expanded in the horizontal direction.

ZOOM size screen

When wide signals are input.

ANAMORPHIC size screen

Information

Supported resolution

See page 37-39 for details on the display output of the various VESA signal standards supported by the monitor.

When 852 (848) dot 480 line wide VGA* signals with a vertical frequency of 60 Hz and horizontal frequency of 31.7 (31.0) kHz are in- put

Select an appropriate setting for RGB SELECT mode referring to the“Table of Signals Supported” on page 37-39.

*“VGA”, “SVGA” and “SXGA” are registered trademarks of IBM, Inc. of the United States.

Note:

Do not allow the displayed in 4:3 mode for an extended period. This can cause a phosphor burn-in.

17

Image 18

Contents Model PD6150D User Guide Important Safety Instructions Avertissment Before requesting service What is covered?What is excluded? To get warranty serviceImportant Information Recommandations importantes AvertissementDOC avis de conformation To avoid damage and prolong operating life PrecautionsPlasma monitor cleaning procedure Recommendations to avoid or minimize phosphor burn-inPrécautions Mises en garde et précautions de sécuritéMéthode de nettoyage du moniteur à plasma Contents Installation Ventilation Requirements for enclosure mountingHandling the remote control How to use the remote controlBattery Installation and Replacement Cable ManagementPart Names and Function Turns the monitor’s power on and offReceives the signals from the remote control Front ViewRear View/ Terminal Board Remote Control Basic Operations When viewing videos or digital video discs Wide Operations Supported resolution Wide Screen Operation with Computer SignalsWhen wide signals are input Normal size screen 43 or SxgaOSM On Screen Menu Controls Menu OperationsMenu Tree Main menu Sub menu Sub menu 3 Sub menuOnly when Auto Picture is OFF RGB/PC only Restoring the factory default settingsAdjusting the picture Picture Settings MenuStoring picture settings Reducing noise in the pictureMaking the Low Tone adjustments Setting the color temperatureAdjusting the color to the desired level Changing the Gamma CurveAdjusting the pedestal level black level Adjusting the colorsSetting the picture to suit the movie Setting the allocation of the audio connectors Audio Settings MenuImage Adjust Settings Menu Adjusting the Position, Size, Fine Picture, Picture ADJSET UP Settings Menu Setting the signal and black level for Hdmi signal Setting the video signal formatSetting the background color when no signal is being input Resetting to the default values Setting the screen size for S1/S2 video inputSetting the position of the menu Turning on/off the menu displayPOWER/STANDBY indicator Function Settings MenuSetting the power management for computer images Setting the Input SkipINVERSE/WHITE Settings Peak Bright settingsOrbiter settings Soft Focus settingsSignal Information Menu Setting Closed CaptionReducing the brightness of Closed Caption External Control Pin AssignmentsTroubleshooting Symptom Checks RemedySpecifications PD6150D SignalsTable of Signals Supported PD6150D Supported resolutionComputer input signals supported by this system Declaration of Conformity Is a registered trademark