CHAPTER 2
Setup and Configuration
To connect the Roadster Orbital Head to a DMX link:
1.Connect the male XLR connector of a DMX data cable to the controller’s DMX ‘data out’ connector.
2.Connect the Data cable’s female XLR connector to the ‘data in’ connector of the first (or next) unit on the DMX link. This connection is on the Power hub for the Orbital Head system.
Place a terminator in the ‘data out’ connector of last fixture on the link
Daisy-chaining Power Hubs in a DMX 512 link
3.Continue linking the remaining fixtures connecting a cable from the ‘data out’ (data thru) connector of each fixture to the ‘data in’ connector of the next fixture on the link.
4.Connect a male terminator to the ‘data out’ connector of the last fixture in the link.
Powering On the System
Warnings: Connect this equipment only to a branch circuit having a maximum overload protection of 20 A.
The Mirror Head moves under remote control, and is designed for use by proficient technicians in a professional environment.
Caution: Do not power on the fixture until verifying that the line cord cap is suitable for the power source in your location.
Keep hands free from the Mirror Head when powering up the system to avoid a pinching hazard as the Mirror Head begins to move during automatic homing.
Before Applying Power
•Manually rotate the Mirror Head, checking that it can move freely on both axes without hitting the projector or any rigging hardware.
•Ensure that all cables, set pieces etc. are clear of the equipment.
•Keep all clothing and body parts clear of the equipment.
•Ensure that the equipment may not be accessed by the public or unqualified persons.
Applying Power
Caution: Keep hands free from the Mirror Head when powering up the system to avoid a pinching hazard as the Mirror Head begins to move during automatic homing.
14 | Roadster Orbital Head System User Manual |