Marantz VP-12S2 manual Setting the Config Menu, Setting the Trigger 2 Menu, On Output DC

Page 31

❖Setting the Config Menu

1.Use 3 / 4 key to adjust.

2.Use 1 key to go back to the menu item.

1.

2.

ENGLISH 1.

2.

Trigger 2

Select either 12V output or 0V output by choosing On or Off for each aspect mode. Full, Normal, Zoom, and Through.
PictureAdjust	Full
On: Output DC 12V.
Setting	Normal
Off: No output.	Through
Display	Through	On
Config	Zoom	On
Trigger2
Memory

This allows you to control such as a powered dual aspect screen with the outputs for the aspect modes.

❖Setting the Trigger 2 Menu

1.Use 3 / 4 key to adjust.

2.Use 1 key to go back to the menu item.

1.

2.

1.

2.

27

Image 31

Contents Model VP-12S2 User Guide For the customers in the USA Important Safety Instructions Table of Contents Replacement Important SafeguardsOptics FeaturesElectronics & Software Accessories Projection Lens IR sensor Front and Top ViewTerminals Rear and Terminals ViewBottom View ¡0THEATER key P.28 Remote ControllerRemote Controller Operational Range Preparing the Remote ControllerConnection When making connections be sure toWhen pulling out a cable Connection with AC Power SupplyAdvanced Connection Connection with a HD-Video, Satellite, Cable Tuner or PCAdjusting the Image Position Initial SettingTurning on the Power Zooming and FocusingCounterclockwise Down Adjusting the HeightDetail Focusing Returning the Projector to its Initial PositionKeystone Correction Mounting on the ceiling InstallationRecommended Setting Installing on a tabletop16 9 Screen Screen Size and Projection Distance inchScreen Diagonal Width Height Minimum Maximum Inch Screen Size and Projection Distance mSelecting the Aspect Mode Selecting the Input Signal SourceBasic Operations Screen Images in a 169 screen Screen Images in a 43 screen To Turn off the Power Menu Structure OperationsColor Temp. Temperature Using On-Screen MenuPicture Adjust Setting the Picture Adjust MenuChrominance DelayFine Menu LuminanceMiscellaneous Sub Control Setting the Setting Menu SettingDisplay Setting the Display MenuConfiguration On Output DC Setting the Config MenuSetting the Trigger 2 Menu TriggerLamp Life Setting the Memory MenuMemory Lamp Life and Replace LampInitialize the Lamp Life How to replace the Lamp Unit MaintenanceReplacing Lamp Unit Replacement Parts Cleaning the LensOptional Accessories Error Mode TroubleshootingOn Screen Message SpecificationsGlossary Timing chartBottom DimensionsTop FrontIs a registered trademark