ENGLISH
TROUBLESHOOTING
Try the following troubleshooting before calling for service.
1.Are the connections made properly ?
2.Are you operating the unit properly, following the instructions ?
If the unit does not operate properly, check the items shown in the following table.
If any trouble cannot be solved by the instructions below, malfunction of the internal circuitry is suspected; immediately unplug the AC power cord and contact Marantz dealer or service center.
Symptom | Possible Cause | Remedy | |
No power | AC power cord is not connected correctly. | Connect the AC power cord properly. | |
|
|
| |
| Lamp cover is not closed correctly. | Close the cover properly. | |
Image is not displayed. | A signal cable is not connected correctly. | Connect a signal cable properly. | |
|
|
| |
| Selected input is incorrect. | Select the correct input source . | |
|
|
| |
| The picture mute is active. | Press the MUTE key to release the mute. | |
Poor color. | Picture is not adjusted properly. | Adjust the picture in the MENU mode. | |
Picture is too dark. | Lamp life is running out. | Replace the lamp. | |
|
| ||
Contrast or brightness is not adjusted properly. | Adjust contrast or brightness properly. | ||
| |||
Picture is not clear. | Picture is out of focus. | Adjust the focus. | |
|
| ||
Dew is on the lens. | Run the projector for about two hours. | ||
| |||
Picture rolls. | A signal cable is not properly connected. | Connect a signal cable properly. | |
| Batteries are exhausted. | Replace batteries. | |
|
|
| |
| The distance to the unit is too far. | Make the distance between the unit and the | |
The Remote Controller | remote control closer. | ||
| |||
|
| ||
does not work. | IR sensor on unit is obstructed. | Remove any obstacles. | |
|
|
| |
| The “EXTERNAL” position on the connector | Select the “INTERNAL” position. | |
| panel is selected. |
| |
|
|
|
Note:
•If the lamp still does not function after the replacement and initialization of the lamp life, contact a Marantz authorized dealer, or service center.
ERROR MODE
WARNING/LAMP indicator, POWER ON indicator, and STANDBY indicator diagnose error mode of the projector as follows.
Error mode |
| Indicators |
| Possible Cause | Recommendation | |
WARNING | POWER ON | STANDBY | ||||
| /LAMP |
|
| |||
|
|
|
|
| ||
Lamp cover | ON | OFF | Flashing | The lamp cover is not | Close the cover correctly. | |
closed properly. | ||||||
|
|
|
|
| ||
Lamp | ON | OFF | OFF | The lamp has failed, or | Replace the lamp and | |
the lamp is completely | reset lamp life. | |||||
|
|
|
| worn out. | ||
|
|
|
|
| ||
Lamp | Flashing |
|
| Temperature around |
| |
ON | Flashing | the lamp unit becomes |
| |||
temperature |
| |||||
|
|
| unusually high. |
| ||
|
|
|
| Check that nothing is | ||
|
|
|
| Temperature around | ||
|
|
|
| blocking the ventilation | ||
Power supply |
|
|
| the power supply | ||
Flashing | ON | OFF | holes, and leave off the | |||
becomes unusually | ||||||
|
|
|
| high. | unit for about an hour. | |
|
|
|
|
| ||
|
|
|
|
|
| |
Fan | Flashing | OFF | ON | The fan inside the |
| |
projector has stopped. |
| |||||
|
|
|
|
|
32