Figure 2-6. Connecting the monitor cables
To control your computer mouse using the projector remote control, connect the projector to the computer with a USB cable (not included), as shown in Figure
Figure 2-7. Connecting the projector and computer with a USB connector
Using the projector with Windows 98
The first time you connect a computer running Windows 98 to the projector, the computer recognizes the projector as “new hardware” and the Add New Hardware Wizard screen appears. To use the Wizard to load the correct driver (which was installed with your Windows operating system), complete the following procedure:
Note: If you are running Windows 2000 or Windows ME, skip these steps and continue with “Adjusting the image” on page
1.After the Add New Hardware Wizard screen appears, click Next to begin searching for the driver.
2.Select Search for the best driver.
3.Click Next.
4.Uncheck any checked boxes, then click Next. Windows automatically locates the driver. If this driver has been removed, reload the driver using your Windows operating system CD.
5.When Windows finds the driver, click Next to install the driver.