IBM Partner Pavilion iLV300 manual Projector LEDs, LED color Meaning

Table B-1. Troubleshooting (continued)

Problem	Solution
The image does not fit in the 4:3	Change the aspect ratio to 4:3 or 16:9 in the
or 16:9 screen.	Picture>Aspect ratio menu.
The image is upside down.	Turn off ″ceiling″ in Settings>System menu.
The image is reversed to the left	Turn off the rear in Settings>System menu.
or right.
The projected colors do not match	Adjust the color, tint, color temperatures, brightness,
the source.	and contrast in the menus.
The lamp will not turn on and	v Make sure the vents are not blocked.
the red LED is blinking.	v Turn off the projector and allow it to cool for a
	minute.
	v Check the lamp hours, by selecting Main>About. If
	the lamp hours are greater than 3,000, then the lamp
	must be replaced. For instructions on replacing the
	lamp, see “Replacing the projection lamp” on
	page A-1.
The ″Change lamp″ message	Check the lamp hours, by selecting Main>About. If the
appears at startup.	lamp hours are greater than 3,000, then the lamp must
	be replaced. For instructions on replacing the lamp, see
	“Replacing the projection lamp” on page A-1.

Projector LEDs

The LED on top of the projector indicates the state of the projector and can help you troubleshoot.

Table B-2. Projector LEDs

LED color	Meaning
solid green	The power switch has been toggled on and
	the software has initialized or the projector
	has been powered off via the remote.
blinking green	The power switch has been toggled on and
	the software is initializing, or the projector is
	powering down and the fans are running to
	cool the lamp.
blinking red	A fan or lamp failure has occurred. Make
	sure the vents are not blocked. Turn off the
	projector and wait one minute, then turn the
	projector on again. If the projector has been
	working for 3,000 hours or more, replace the
	lamp and reset the lamp timer. For
	instructions on replacing the lamp, see
	“Replacing the projection lamp” on
	page A-1.Contact IBM technical support if
	the problem persists.
solid red	An unidentifiable error. Please contact IBM
	technical support.

If the projector is not functioning properly and the LED is blinking red, see Table B-3 on page B-3to determine a possible cause. There are two-second pauses between the blinking cycles. For more details on LED projector errors, contact your

B-2IBM iLV300 Value Data/Video Projector: User’s Guide