If you are running Windows 98 and you connected the USB cable, the Add New Hardware Wizard appears again. Drivers must be installed to use the USB functionality. The Wizard launches three times:
vThe first time it detects a USB Composite Device.
vThe second time a USB Human Interface Device (for the keyboard).
vThe third time it detects a USB Human Interface Device (for the mouse).
Displaying a computer source image
To display a computer source, complete the following procedure:
1.Remove the lens cap.
2.Toggle the power switch on the side of the projector to the on position.
The LED flashes green and the fans start to run. When the lamp comes on, the start up screen displays and the LED is steady green. It can take a minute for the image to achieve full brightness.
3.Turn on your computer.
The computer image should appear on the projection screen. If it does not, press the Computer button on the projector keypad.
If your computer has Windows 98 as its operating system, see “Using the projector with Windows 98” on page
4.Make sure your laptop external video port is active.
Many laptops do not automatically turn on their external video port when a projector is connected. Usually a key combination like FN + F7 is used to turn the external display on and off. Refer to your laptop documentation to learn your laptop’s key combination.
Adjusting the image
To adjust the image, complete the following procedure:
1.Adjust the height of the projector, if necessary, by pressing the release button to extend the foot, as shown in Figure
1 Elevator foot 2 Release button
Figure 2-8. Adjusting the height of the projector
2.If necessary, rotate the leveling foot located at the rear of the projector, as shown in Figure
Chapter 2. Setting up the projector