Gateway GT115 manual Environmental specification

Page 16

Environmental specification

Item

Description

Temperature range

 

Operating

535°C (4195°F)

Non-operating

-2060C (-4140°F)

 

 

Humidity (non-condensing)

 

Operating

30–80% RH

Non-operating

20–90% RH

 

 

Acoustic noise

 

Full Configuration

Sound pressure level in idle mode on bystander

 

 

position 38 dBA

 

Sound pressure level in full loading on bystander

 

position 45 dBA

Light Configuration

Sound pressure level in idel mode on bystander

 

 

position 35 dBA

 

Sound pressure level in full loading on bystander

 

position 40 dBA

 

 

*All temperature ratings shown are for sea level. An altitude derating of 1¢XC per 300 m (1.8¢XF per 1,000 ft) to 3048 m (10,000 ft) is applicable. No direct sunlight allowed.

**Storage maximum humidity of 95% is based on a maximum temperature of 45¢XC (113¢XF). Altitude maximum for storage corresponds to a pressure minimum of 70 KPa.

12

Image 16
Contents Service Guide Gateway GT115Date Chapter Updates PrefaceRevision History CopyrightConventions Screen messagesPreventing electrostatic discharge Safety, Care and Regulatory InformationServer warnings and cautions Table of Contents Cable Routing image Main Menu Advanced MenuBios Post error message list PEI Phase DXE Phase Error Symptoms ListSecurity Menu Mechanical Components DescriptionPage System FRU List Photo Part numberFront Bezel Assembly Power Supply System components DescriptionHardware specification System SpecificationsSystem unit Processor General processor specifications MemoryEnvironmental specification Mechanical specification Power supply specification Page Front view Appearance of SystemItem Component Rear view Icon Component DescriptionLED indicator Internal ComponentSwitch and LED Indicators Introduction Front Panel LED DescriptionHard Disk Drive Sequence & LED Description LAN Port LED DescriptionPage System Block Diagram SIOMotherboard Placement and Jumper Setting Motherboard ComponentConnector Icon Description Code DescriptionMotherboard Jumper Setting Installing/Removing system Hardware Removing the side cover Chassis Cover Removal and InstallationRemoving the tower foot CPU Installation / Removal Cooling Fan Installation / Removal Installation step Memory Installation / RemovalMemory Suggest Population Table PCI Expansion Card Installation / Removal Install the expansion cardHard Disk Drive Installation / Removal Power supply installation / Removal Install a hot-swap power supply moduleCable Routing image Cable RoutingSuggest Cable Bios Setup System BiosBios Setup Primary Menus Entering Bios SetupBios Setup Navigation Keys Main Menu Parameter DescriptionAdvanced Menu Processor Configuration Parameter Description OptionCpuid Memory Configuration Sata Controller Configuration AchiPCI Configuration USB Configuration Legacy Device Configuration Console Redirection VT-UTF8Page Power Configuration Hardware Monitor Security Menu Changing a System Password Setting a System PasswordRemoving a System Password Server Menu System Information Event Log Configuration Boot Option Menu Page Boot Manager Menu Exit Menu Troubleshooting Error Symptoms ListError Symptom Action/FRU Processor / Processor Fan Main board and MemoryCD/DVD-ROM Drive Video and MonitorPower Supply Other ProblemsParallel/Serial Ports KeyboardBios Beep Codes Bios Beep Codes TableBios Recovery Instruction PEI Beep CodesPage Recovery Stage Bios Post error message list Bios Post Error Messages ListPEI Phase DXE Phase Page Undetermined Problems  Dimm