Gateway GT115 manual Memory Configuration

Page 44

Memory Configuration

Parameter

Description

Option

Available Memory

Total size of system memory detected during POST

 

 

 

 

On-line Spare DIMM

Enable this feature will reserve one rank of one

Enabled

 

logical DIMM to be used as spare rank. This rank

Disabled

 

will be used when any other rank no longer

 

 

functions properly.

 

 

 

 

Channel interleaving

This feature provides compensating the relatively

Enabled

 

slow speed of DRAM. The CPU can access

Disabled

 

alternative sections immediately without waiting for

 

 

memory to be cached. Multiple memory banks take

 

 

turns supplying data.

 

Chip Select interleave

 

Enabled

 

 

Disabled

 

 

 

Memory Retest

Select whether to delete the historical memory data

Yes

 

log. System memory will be retested on the next

No

 

boot-up.

 

 

 

 

DIMM Group #1A/1B/2A/2B

The size of memory installed on each of the DDR3

 

Status

slots.

 

 

 

 

40

Image 44
Contents Service Guide Gateway GT115Date Chapter Updates PrefaceRevision History CopyrightConventions Screen messagesServer warnings and cautions Safety, Care and Regulatory InformationPreventing electrostatic discharge Table of Contents Cable Routing image Main Menu Advanced MenuSecurity Menu Error Symptoms ListBios Post error message list PEI Phase DXE Phase Mechanical Components DescriptionPage System FRU List Photo Part numberFront Bezel Assembly Power Supply System components DescriptionSystem unit System SpecificationsHardware specification Processor General processor specifications MemoryEnvironmental specification Mechanical specification Power supply specification Page Item Component Appearance of SystemFront view Rear view Icon Component DescriptionLED indicator Internal ComponentSwitch and LED Indicators Introduction Front Panel LED DescriptionHard Disk Drive Sequence & LED Description LAN Port LED DescriptionPage System Block Diagram SIOMotherboard Placement and Jumper Setting Motherboard ComponentConnector Icon Description Code DescriptionMotherboard Jumper Setting Installing/Removing system Hardware Removing the tower foot Chassis Cover Removal and InstallationRemoving the side cover CPU Installation / Removal Cooling Fan Installation / Removal Memory Suggest Population Table Memory Installation / RemovalInstallation step PCI Expansion Card Installation / Removal Install the expansion cardHard Disk Drive Installation / Removal Power supply installation / Removal Install a hot-swap power supply moduleSuggest Cable Cable RoutingCable Routing image Bios Setup System BiosBios Setup Navigation Keys Entering Bios SetupBios Setup Primary Menus Main Menu Parameter DescriptionAdvanced Menu Processor Configuration Parameter Description OptionCpuid Memory Configuration Sata Controller Configuration AchiPCI Configuration USB Configuration Legacy Device Configuration Console Redirection VT-UTF8Page Power Configuration Hardware Monitor Security Menu Removing a System Password Setting a System PasswordChanging a System Password Server Menu System Information Event Log Configuration Boot Option Menu Page Boot Manager Menu Exit Menu Troubleshooting Error Symptoms ListError Symptom Action/FRU Processor / Processor Fan Main board and MemoryCD/DVD-ROM Drive Video and MonitorPower Supply Other ProblemsParallel/Serial Ports KeyboardBios Beep Codes Bios Beep Codes TableBios Recovery Instruction PEI Beep CodesPage Recovery Stage PEI Phase Bios Post Error Messages ListBios Post error message list DXE Phase Page Undetermined Problems  Dimm