Gateway GT115 manual

Page 19

Depth

140 mm (5.5 in.)

Width

150 mm (5.9 in.)

 

 

Weight (approximate)

1.43 kg (3.1 lb)

 

 

Input requirements

 

Rated input voltage

100–127 VAC, 220–240 VAC

Normal line voltage

115 VAC, 230 VAC

 

 

Line frequency

47–63 Hz

 

 

Rated input current

Load 8A at 100–127 VAC, 4A at 220-240 VAC

 

 

Inrush current

No damage

 

 

Power supply output power

 

Rated steady state power

450W

Maximum peak power

450W

 

 

Operating conditions

 

Temperature

5–50 C (41–122°F)

Humidity (non-condensing)

5–95% at +55 C

 

 

15

Image 19
Contents Gateway GT115 Service GuideCopyright Date Chapter UpdatesPreface Revision HistoryScreen messages ConventionsPreventing electrostatic discharge Safety, Care and Regulatory InformationServer warnings and cautions Table of Contents Main Menu Advanced Menu Cable Routing imageBios Post error message list PEI Phase DXE Phase Error Symptoms ListSecurity Menu Description Mechanical ComponentsPage Photo Part number System FRU ListFront Bezel Assembly Power Supply Description System componentsHardware specification System SpecificationsSystem unit Memory Processor General processor specificationsEnvironmental specification Mechanical specification Power supply specification Page Front view Appearance of SystemItem Component Icon Component Description Rear viewInternal Component LED indicatorLAN Port LED Description Switch and LED Indicators IntroductionFront Panel LED Description Hard Disk Drive Sequence & LED DescriptionPage SIO System Block DiagramMotherboard Component Motherboard Placement and Jumper SettingCode Description Connector Icon DescriptionMotherboard Jumper Setting Installing/Removing system Hardware Removing the side cover Chassis Cover Removal and InstallationRemoving the tower foot CPU Installation / Removal Cooling Fan Installation / Removal Installation step Memory Installation / RemovalMemory Suggest Population Table Install the expansion card PCI Expansion Card Installation / RemovalHard Disk Drive Installation / Removal Install a hot-swap power supply module Power supply installation / RemovalCable Routing image Cable RoutingSuggest Cable System Bios Bios SetupBios Setup Primary Menus Entering Bios SetupBios Setup Navigation Keys Parameter Description Main MenuAdvanced Menu Parameter Description Option Processor ConfigurationCpuid Memory Configuration Achi Sata Controller ConfigurationPCI Configuration USB Configuration Legacy Device Configuration VT-UTF8 Console RedirectionPage Power Configuration Hardware Monitor Security Menu Changing a System Password Setting a System PasswordRemoving a System Password Server Menu System Information Event Log Configuration Boot Option Menu Page Boot Manager Menu Exit Menu Main board and Memory TroubleshootingError Symptoms List Error Symptom Action/FRU Processor / Processor FanVideo and Monitor CD/DVD-ROM DriveKeyboard Power SupplyOther Problems Parallel/Serial PortsPEI Beep Codes Bios Beep CodesBios Beep Codes Table Bios Recovery InstructionPage Recovery Stage Bios Post error message list Bios Post Error Messages ListPEI Phase DXE Phase Page  Dimm Undetermined Problems