JVC DLA-S15U Bottom Surface, Air intake area filter, Opening for replacing the light-source lamp

Controls and Features (cont.)

Bottom Surface

r

t

y

u

rAir intake area (filter)

Air is taken in through this area to cool the light-source lamp. If this area is blocked or if something that obstructs taking in or exhausting air is placed around the projector, heat may build up inside and could cause a fire. For details, refer to “Precautions for Installation” on page 15.

CAUTIONS

•Be careful as paper, cloth or soft cushion could be drawn in if placed nearby. Do not block the intake area, or heat may build up and could cause a fire.

•Clean the filter periodically. For details, refer to “Cleaning and Replacing the Filter” on page 51.

Deposition of dirt on the filter works to reduce the cooling effect, causing heat to build up inside, which could cause a fire or malfunction.

tOpening for replacing the light-source lamp

For replacing the light-source lamp, refer to “Replacing the Light-Source Lamp” on page 48.

yFixing foot

Under the rubber seal of the$‰7ttom of this foot, there is a tapped hole. (Screw size available here is M8.)

uPosition selecting screw for ceiling mounting When using the projector in an upside-down, ceiling- mounted position (inverted top-to-bottom and right-to-left), the “position selecting screw for ceiling mounting” must be turned to switch to ceiling mounting.

This will correct variance in color images (shading), which otherwise would occur in ceiling mounting.

For more information, refer to “position selecting screw for ceiling mounting” on page 18.

CAUTION

•To ceiling-mount and adjust the projector, special expertise and technique are necessary. Be sure to ask your dealer or a specialist to perform this work.

8